User manual SEGA DAYTONA USA 2 DX

[. . . ] TEST 7-5 INPUT TEST 7-6 OUTPUT TEST 7-7 SOUND TEST 7-8 C. R. T. TEST 7-9 GAME ASSIGNMENTS 7-10 COIN ASSIGNMENTS 7-11 BOOKKEEPING 7-12 BACKUP DATA CLEAR 8. MAINTENANCE OF HANDLE AND SHIFT LEVER 8-1 ADJUSTMENT AND REPLACEMENT OF SWING VOLUME 8-2 GREASING 8-3 REMOVING SHIFT LEVER 8-4 SWITCH REPLACEMENT 9. ACCEL & BRAKE (S) 9-1 ADJUSTMENT AND REPLACEMENT OF VOLUME 9-2 GREASING 9-3 HAND BRAKE 10. [. . . ] Press the SET BUTTON and SELECT BUTTON (UP). By opening the Coin Chute Door, insert a coin from the Coin Inlet to check the Coin Chute Tower. http://www. sauservice. com/manuals/DAYTONA2_html%20TWIN/13day2twin. html 7/12/2005 Test Mode Page 3 of 4 When INPUT TEST is selected, the MONITOR will show the following, allowing you to watch the status of each switch and the value of each V. R. of the cabinet to be viewed On the screen, periodically check the status of each switch & V. R. By pressing each switch, if the display on the right-hand side of the name of each switch changes to ON from OFF, the SW and the wiring connections are satisfactory. PITCH refers to the Switch for the left/right Foot Pedal's UP/DOWN. Normally, this is ON and stepping on the Pedal's front side causes the Switch to become off. 7 - 6 OUTPUT TEST Choose OUTPUT TEST to cause the following lower screen to appear. In this test, check the status of each lamp. Pressing the TEST BUTTON causes "ON" to be displayed and the corresponding lamp lights up. Pressing the TEST BUTTON again causes "OFF" to be displayed and the lamp goes off. The Foot Controller is locked with the Slide Lock in the ON status, and Unlocked to become free with the Slide Lock in the OFF status. Press the test Button to return to the MENU MODE. 7 - 7 SOUND TEST This enables sound used in the game to be checked. Sound related memory and each speaker are checked. Note that that contents of the GAME SETTING, COIN SETTING, and VOLUME SETTING are not affected by BACKUP DATA CLEAR operation. http://www. sauservice. com/manuals/DAYTONA2_html%20TWIN/21day2twin. html 7/12/2005 Mecha Unit/ Adjustment Page 1 of 5 [Previous page][Next page][Table of Contents] 8 . MAINTENANCE OF HANDLE AND SHIFT LEVER In order to prevent an electric shock and short circuit, be sure to turn power off before performing work by touching the interior parts of the product. Damaged wiring can cause an electric shock or short circuit accident. This work should be performed by the Location's Serviceman. Performing work by non-technical personnel can cause shock hazard. Don not touch places other than those specified. Touching places not specified can cause an electric shock accident. In the test mode, if the handle V. R. value movements are irregular, adjust or replace the V. R. in the following procedure. 8 - 1 REMOVING THE CONTROL PANEL (1) Turn the Power off. (2) Remove a total of 4 tamperproof screws from both sides of the of the control panels front. (3) Remove the two tamperproof screws from the underside of the control panel. http://www. sauservice. com/manuals/DAYTONA2_html%20TWIN/22day2twin. html 7/12/2005 Mecha Unit/ Adjustment Page 2 of 5 (4) Wiring connectors are connected inside the control panel in a manner so as not to damage wiring. (5) Disconnect the wiring connector 8 - 2 REPLACING/ ADJUSTING THE HANDLE'S V. R. REPLACING THE VOLUME (1) Turn off the power/ (2) Disconnect the Connector. (3) Take out the 2 screws which secure the Volume Bracket and remove the Volume Bracket (4) Take out the 2 screws to remove the Volume Gear and replace Volume. [. . . ] DUT-10001 DUT-11001 DUT1-0200 SPG-0300 422-0661-01 LOCAL PURCHASE 999-0589 DESCRIPTION ASSY COCKPIT 1P ASSY COCKPIT 2P ASSY BILLBOARD ASSY COIN CHUTE TOWER SUB INSTR SH DUT TWIN MONITOR GLASS TEMPERED MONITOR GLASS BRKT http://www. sauservice. com/manuals/DAYTONA2_html%20TWIN/34day2twin. html 7/12/2005 Top Assy Daytona USA 2 TWIN Page 2 of 2 8 9 15 16 17 19 20 21 22 23 24 25 27 28 29 999-0590 999-0591 421-8543 421-8544 421-7308~ NOT USED IN US SPG-0006 DYN-0006X INY-0004 DYN-0008 DYN-0009 DYN-0011 SEE DISTRIBUTOR DUT-0002 DUT1-0003 SIDE MONITOR GLASS BRKT UPPER MONITOR GLASS BRKT LOWER STICKER CABINET L STICKER CABIENT R DENOMINATIN SHEET 1 GAME~ BLIND CAP AC COVER A AC COVER B BACK LID INY BACK LID B HOLE LID DENOMI PLATE W/O ORIGINAL DISPLAY CARD DUT TWIN POP BRKT BILLBOARD BASE http://www. sauservice. com/manuals/DAYTONA2_html%20TWIN/34day2twin. html 7/12/2005 ASSY BILLBOARD Page 1 of 1 [Previous page][Next page][Table of Contents] ASSY BILLBOARD (999-0706) ITEM NO. 999-0704 999-0715 999-0710 999-0712 LOCAL PURCHASE DESCRIPTION BILLBOARD PLATE LOWER PLEX DUT2 STD MARQUEE CAP LEFT MARQUEE CAP RIGHT ASSY FL 20W EX W/CONN HIGH S http://www. sauservice. com/manuals/DAYTONA2_html%20TWIN/35day2twin. html 7/12/2005 ASSY COIN CHUTE TOWER Page 1 of 2 [Previous page][Next page][Table of Contents] ASSY COIN CHUTE TOWER (DUT-0300) ITEM NO. 1 2 3 4 5 10 11 12 13 101 102 PART DESCRIPTION NO. SPG-0350 SW UNIT SPG-0301 COIN CHUTE TOWER DYNCOIN METER BRKT 0302Y DP-1167 TNG LKG BOXCASH BOX CASH DYN-0305 TOWER BRKT 105-5202 HOLE COVER SPG-0302 WIRE BOX SPG-0303 WIRE BOX LID 220-5237ASSY C. C. DOOR 2DR 92 220-5412 MAG CNTR W/CONN http://www. sauservice. com/manuals/DAYTONA2_html%20TWIN/36day2twin. html 7/12/2005 ASSY COIN CHUTE TOWER Page 2 of 2 103 104 105 220-541201 220-5574 220-5575 MAG CNTR W/CONN BLACK CAM LOCK W/KEYS CAM LOCK MASTER W/O KEY http://www. sauservice. com/manuals/DAYTONA2_html%20TWIN/36day2twin. html 7/12/2005 ASSY SW UNIT Page 1 of 1 [Previous page][Next page][Table of Contents] SW UNIT (SPG-0350) ITEM NO. [. . . ]