User manual SEGA DAYTONA2

[. . . ] ACCELERATOR & BRAKE 10ADJUSTMENT AND REPLACEMENT OF VOLUME 1 10GREASING 2 11. 4-SPEED SHIFTER 11REMOVING THE SHIFTER 1 11REPLACING THE SWITCH 2 http://www. sauservice. com/manuals/Daytona%20Folder/DDhtml/DD00. html 7/12/2005 Daytona USA Deluxe Owner's Manual Page 2 of 2 113 114 12. 171 172 173 18. GREASING REPLACEMENT OF RUBBER STOPPERS COIN SELECTOR PROJECTOR CLEANING THE SCREEN HITACHI PROJECTOR MITSUBISHI PROJECTOR REPLACING THE FLUORESCENT LAMP PERIODIC CHECK TROUBLESHOOTING GAME BOARD REMOVING THE BOARD COMPOSITION OF GAME BOARD INPUT AND OUTPUT RELATIONS DESIGN RELATED PARTS 38 38 39 40~43 40 41 42 44 44 45 46~47 46 47 47 48~49 50~96 97 98~99 19. WIRING DIAGRAM http://www. sauservice. com/manuals/Daytona%20Folder/DDhtml/DD00. html 7/12/2005 Introduction of the Owner's Manual Page 1 of 2 [Table of Contents][Next Page] SPECIFICATIONS Installation space Height Weight Power, maximum current 1, 140 mm (W) x 2, 800 mm (D) (44. 9 in. [. . . ] 8. 8 DRIVE BD TEST Bring the arrow (>>) to the desired item by using the SERVICE SW or VR1 (red) or VR4 (green). The steering wheel functions to the setting selected by the arrow. Pressing VR2 (blue) or VR3 (yellow) allows the force transmitted to the steering wheel to increase or decrease. Status in which the motor and clutch are not activated. Centering of the handle is caused by only the spring inside the handle mechanism. CLUTCH: Status in which the clutch is activated. CENTERING: Status in which the handle (of itself) returns to the center position. UNCENTERING: Status in which the handle is caused not to be in the center. ROLL LEFT: Status in which the handle is rotated in the left-hand side direction ROLL RIGHT: Status in which the handle is rotated in the right-hand side direction. EXIT: Causes the menu mode to return on to the screen. SPRING: http://www. sauservice. com/manuals/Daytona%20Folder/DDhtml/DD28. html 7/12/2005 Sound Test Page 1 of 1 [Table of Contents] [Previous Page] [Next Page] 8-9 SOUND TEST Choosing SOUND TEST causes the following mode to appear on the screen. Also, note that the game setting contents are not affected by BACKUP RAM CLEAR operation. FIG. 8. 12 BACKUP RAM http://www. sauservice. com/manuals/Daytona%20Folder/DDhtml/DD32. html 7/12/2005 Handle's V. R. Page 1 of 2 [Table of Contents] [Previous Page] [Next Page] 9. CONTROL PANEL (HANDLE MECHA) In the TEST mode, if the steering wheel V. value variations are not within the allowable range, an adjustment of the V. installation position or replacement of the V. Also, apply grease to the steering wheel mechanism's shaft and sliding portions once every 3 months. When carrying out the above work, take off the 4 truss screws and remove the front cabi's Front Lid Upper. 9-1 REPLACING AND ADJUSTING THE HANDLE's (STEERING WHEEL's) V. R. FIG. of the HANDLE MECHA is for the GAME BD. , and the lower side one. is as follows: When the steering wheel is Left Centering position Right turned to or positioned at: V. for the GAME BD. : Under 2 DH --7DH~83H --> Over D3H V. [. . . ] Disconnect all of the wiring connectors from the shield case in which the game BD and I/O BD are incorporated. Pull out the base (on which the shield case is mounted) by taking off the 2 screws. Take off the 3 screws and remove the case lid by causing it to slide. Unlock and take off the 2 screws to remove the rear cabi's service door. [. . . ]