User manual SEGA DERBY OWNERS CLUB WORLD EDITION

[. . . ] www. seuservice. com 1st PRINTING JUNE 02 OWNER'S MANUAL SEGA ENTERPRISES, INC. USA MANUAL NO. 420-6679 VISIT OUR WEBSITE! BEFORE USING THE PRODUCT, BE SURE TO READ THE FOLLOWING: To maintain the safety: To ensure the safe usage of the product, be sure to read the following before using the product. The following instructions are intended for the users, operators and the personnel in charge of the operation of the product. After carefully reading and sufficiently understanding the warning displays and cautions, handle the product appropriately. [. . . ] Changes to these settings could cause malfunctioning. DIP SW 1 represents the communication setting. OFF DIP SW 3 DIP SW 2 DIP SW 1 PHOTO 8 DIP SW 2 and 3 are for minute adjustments prior to final shipping. The settings of each card reader/ writer may vary. Changes can result in malfunctions such as a slight divergence in the printing position. www. seuservice. com 50 8 - 1 SETTING THE CARDS STOP IMPORTANT! Please be sure to use the proprietary cards for this product. Usage of other cards could cause malfunctioning or breakdown. Be sure to set the cards in accordance with the specified procedure, direction, and number. Incorrect setting could cause equipment breakdown or other problems. Do not set more than 100 cards, as this could cause problems such as jamming. Use of deformed or degraded cards can cause problems. Do not mix with cards that have been creased, bent, or previously used. The card reader/writer, in which the cards are to be set, is to the left of the monitor screen, as seen when facing the satellite. Cards can be set regardless of whether the power is switched to ON or OFF. Release. RW COVER 1 Release and open the RW cover to reveal the card reader/writer. The card reader/writer contains a card dispenser. CARD READER/WRITER DISPENSER PHOTO 8. 1 a 2 Remove the dispenser by pulling straight up from the card reader/ writer. PHOTO 8. 1 b 51 www. seuservice. com 3 Place the cards in the dispenser in accordance with the instructions on the sticker that appears on the dispenser. Be careful not to place the cards backwards or upside down. The number of cards that can be placed in the dispenser at any one time is 100. In order to avoid problems such as jamming, be sure not exceed this limit. Use new packages of 100 cards, or else carefully count the number of cards before placing them in the dispenser. Use the sticker on top of the dispenser to determine correct direction of the cards. Magnetic Card Remove the dispenser, and open the cover. Insert the cards, paying attention to their orientation. Close the cover and replace the dispenser. FIG. 1 DISPENSER 4 5 Place the cover on the dispenser. Place the dispenser back into the card reader/writer. The dispenser is designed to fit only in its correct orientation. 6 Close and lock the RW cover. PHOTO 8. 1 c www. seuservice. com 52 8 - 2 HEAD CLEANING WARNING! When the head cleaning mode is performed manually, never touch any places other than the specified parts. [. . . ] 1 b www. seuservice. com 96 15 - 2 REMOVING THE NAOMI SHIELD CASES 1 2 3 4 5 Turn the power switch in the satellite AC unit to OFF. Release and open the front door of the satellite. Disconnect all the connectors from the shield case filter board. Remove the 4 screws to remove the back door. [. . . ]