User manual SEGA HOUSE OF THE DEAD 4 52

[. . . ] 420-6908-01UK REV 2. 00 SERVICE MANUAL A 52" SHOOTING MINI DELUX GAME Before using this product, read this SERVICE MANUAL carefully to understand the contents stated herein. After reading this manual, be sure to keep it available nearby the product or somewhere convenient in order to be able to refer to it whenever necessary. Manufactured in the UK by MANUFACTURING DIVISION (U. K. ) CONTENTS Before using this product, read this SERVICE MANUAL carefully to understand the contents stated herein. After reading this manual, be sure to keep it available nearby the product or somewhere convenient in order to be able to refer to it whenever necessary. 1. 4. BEFORE USING THIS PRODUCT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 INSPECT IMEDIATELY AFTER TRANSPORTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INTRODUCTION TO THIS SERVICE MANUAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 INSTALLATION AND SERVICE INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 4. 1. [. . . ] TEST mode, check to ensure the monitor is adjusted correctly · Clean screen (switch off machine and remove the plug) Monthly MONITOR Monthly Weekly Monthly IC BOARD MEMORY TEST · In the SOUND TEST mode, check the sound related ROMs DATA CHECK · Check such data as held in the bookkeeping screens, relating to number and length of plays · Clean surfaces · Lubricate seat sliders Note: This appliance shall not be cleaned by a water jet. Monthly EXTERIOR MAINTENANCE Monthly COIN MECHANISM · Check switch operation (if fitted) Monthly 46 9. 1. 1. VTS ASSEMBLY · Do not touch places other than those specified. Touching places not specified could cause an electric shock or short circuit. TEST BUTTON SERVICE BUTTON Opening the Coin Chute door will reveal the VTS Assembly shown above. The function of each switch is as follows. The controls on the left affect the 1P cockpit, those on the right the 2P. TEST BUTTON (TEST SW) SERVICE BUTTON (SERVICE SW) DEMAG <OPTIONAL> VOLUME CONTROL FRONT <OPTIONAL> VOLUME CONTROL REAR <OPTIONAL> Used to enter TEST mode. Refer to the later section detailing TEST mode. Gives credits without registering on the coin counter. NOT USED NOT USED (Please refer to section 6). NOT USED (Please refer to section 6). The control panel switches can also be used in the place of the VTS switches: PLAYER 1 BUTTON can represent the TEST BUTTON within the TEST MODE only. PLAYER 2 BUTTON can represent the SERVICE BUTTON within the TEST MODE only. 47 9. 1. 2. SYSTEM TEST MODE System Test Mode can be used to check the information or the operation of the LINDBERGH board, adjust Monitor colour, and perform coin/credit settings. · When setting changes are made within TEST MODE, be sure to exit from TEST MODE using the exit options. If you turn the power off and then on without having exited correctly the changes you made will not take effect. · Make sure that the control panel support is fixed firmly in place before performing any operations. Closing the control panel with the support loose may lead to accidents. · Be careful not to trap your fingers when closing the control panel. · The details of changes to Test Mode settings are saved when you exit from Test Mode by selecting EXIT from the SYSTEM TEST MENU. Be careful because if the power is turned off before that point, changes to the settings will be lost. If settings other than those specified are used, inappropriate operations or malfunction may occur. Press the TEST Button after powering on the unit to display the following SYSTEM TEST MENU. SYSTEM TEST MENU SYSTEM INFORMATION STORAGE INFORMATION JVS TEST MONITOR TEST SPEAKER TEST COIN ASSIGNMENTS CLOCK SETTING NETWORK SETTING GAME TEST MODE EXIT SELECT WITH SERVICE AND PRESS TEST . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i Use the SERVICE Button to move the cursor to the desired test item. Press the TEST Button to enter the selected item. Press the TEST Button when GAME TEST MODE is selected to change to the Test Menu specific to this game. Refer to the section "9-3 GAME TEST MODE. " After the test is complete, move the cursor to EXIT and press the TEST Button to return to the Game Advertisement screen. 48 a. [. . . ] 1 2 14 15 16 19 30 31 PART NUMBER HDF-0400UK HDF-1000UK 421-7987-HDF-D 421-7988-91UK LB1102 421-7020UI LB1046 LB1130 QTY 1 1 1 1 1 2 1 1 DESCRIPTION ASSY DLP 52" ASSY CABINET DX STICKER ELEC SPEC HDF DX 52 STICKER SERIAL NUMBER UK STICKER DANGEROUS VOLTAGE STICKER CAUTION FORK LABEL TESTED FOR SAFETY LABEL WEEE WHEELIE BIN COMPONENT REFERENCE 92 11. 2. 1 2 5 6 7 8 10 11 12 13 14 PART NUMBER HDF-0401UK HDF-0402UK HDF-0405UK HDF-0406UK HDF-0407UK HDF-0408UK HDF-0430UK 200-6052-LG HDF-0450UK HDF-0480UK HDF-0670UK QTY 1 2 1 1 1 2 1 1 1 1 1 DESCRIPTION BRKT REAR DLP REAR SUPPORT LEG ASSY BANNER R ASSY BANNER L PLATE REAR DLP END CAP BANNER ASSY MASK ASSY DLP 52 LG 52SZ8R ASSY BILLBOARD DX 52 ASSY DLP LWR BASE ASSY SUB BASE COMPONENT REFERENCE 93 ASSY DLP BASE continued. . . . . . . . . . . . . . . . . No. 15 16 PART NUMBER HDF-4000UK HDF-4200UK QTY 1 1 DESCRIPTION ASSY MAIN BOARD ASSY XFMR COMPONENT REFERENCE 94 11. 3. 1 6 7 301 302 303 PART NUMBER HDF-0431UK JPT-1082 838-13145-02 HDF-60009UK HDF-60010UK HDF-60011UK QTY 1 10 10 1 2 7 DESCRIPTION MONITOR MASK 52" HDF IR COVER LED BD GUN SENSE HOD WH MASK EXT 1 WH MASK EXT 2 WH MASK LINK COMPONENT REFERENCE 95 11. 4. [. . . ]