User manual SEGA WATER SKI

[. . . ] 1ST PRINTING NOV. - 1997 TM OWNER'S MANUAL SEGA ENTERPRISES, USA MANUAL NO. 4201-6334-01 Warranty Your new Sega Product is covered for a period of 90 days from the date of shipment. This certifies that the Printed Circuit Boards, Power Supplies and Monitor are to be free of defects in workmanship or materials under normal operating conditions. This also certifies that all Interactive Control Assemblies are to be free from defects in workmanship and materials under normal operating conditions. [. . . ] 7. 2 25 7 - 2 TEST MODE This mainly checks if the operation of the game BD is accurate, and allows for COIN ASSIGNMENTS/GAME ASSIGNMENTS setting and Projector adjustments. TEST MODE 1 MEMORY TEST T. G. P. TEST INPUT TEST OUTPUT TEST SOUND TEST C. R. T. GAME ASSIGNMENTS COIN ASSIGNMNETS BOARD SETTING BOOKKEEPING BACKUP DATA CLEAR >EXIT Push the TEST BUTTON to cause the following TEST MENU to appear: By pushing the SERVICE BUTTON, bring the ">" mark to the desired item and press the TEST BUTTON. After the test is complete, move the ">" mark to "EXIT" and press the TEST BUTTON to return to game mode. 2 3 SELECT WITH SERVICE BUTTON AND PRESS TEST BUTTON FIG. 7. 2 TEST MENU 7 - 3 MEMORY TEST MEMORY TEST <ROM> IC 15 GOOD IC 11 GOOD IC 9 GOOD IC 7 GOOD IC 5 GOOD <RAM> IC 58 GOOD IC 63 GOOD IC 79 GOOD IC 109 GOOD IC 116 GOOD IC 95 GOOD IC 86 GOOD IC 12 GOOD IC 110 GOOD IC 111 GOOD IC 82 GOOD IC 61 GOOD IC 81 GOOD IC IC IC IC IC IC IC IC IC IC IC IC IC IC IC IC IC IC 54 71 73 101 114 87 94 10 102 103 75 69 55 16 12 10 8 5 GOOD GOOD GOOD GOOD GOOD IC 72 GOOD IC 78 GOOD The MEMORY TEST mode is for checking the on-BD memeory IC functioning. "GOOD" is displayed for normal ICs and "BAD" is displayed for abnormal ICs When the test is completed, if the display is as shown left, it is satisfactory. After finishing the test, pressing the TEST BUTTON allows the MENU MODE to return on the screen. IF THE TEST TIME FOR THE MEMORY TEST EXCEEDS 5 MINUTES THE IC BOARD MAY BE DEFECTIVE. GOOD GOOD GOOD GOOD GOOD GOOD GOOD GOOD GOOD GOOD GOOD GOOD GOOD IC 115 IC IC IC IC IC IC IC 100 11 95 97 68 76 54 GOOD GOOD GOOD GOOD GOOD GOOD GOOD GOOD IC 113 GOOD IC IC IC IC IC 9 88 89 60 83 GOOD GOOD GOOD GOOD GOOD PRESS TEST BUTTON TO EXIT FIG. TEST IC 25 IC 23 GOOD GOOD Selecting T. G. P. TEST cuases the functioning of the on-IC-BD T. G. P. (screen display related IC's) to be checked automatically. If the IC is satisfactory, "GOOD" will be indicated and if the IC is not satisfactory, "BAD" will be displayed. PRESS TEST BUTTON TO EXIT 26 7 - 5 INPUT TEST When INPUT TEST is selected, the MONITOR will show the following, allowing you to watch the status of each switch and the value of each V. R. of the cabinet to be viewed On the screen, periodically check the status of each switch & V. R. INPUT TEST SLIDE PITCH LEFT PITCH RIGHT 80H OFF OFF By pressing each switch, if the display on the right-hand side of the name of each switch changes to ON from OFF, the SW and the wiring connections are satisfactory. PITCH refers to the Switch for the left/right Foot Pedal's UP/ DOWN. Normally, this is ON and stepping on the Pedal's front side causes the Switch to become off. Press the TEST BUTTON to have the menu mode return on the screen. Using the Decision (SET) button instead of TEST BUTTON will not allow for exiting from the Input Test Mode. Press the SET BUTTON and SELECT BUTTON (UP). By opening the Coin Chute Door, insert a coin from the Coin Inlet to check the Coin Chute Tower. SELECT (UP) SET SELECT (DOWN) OFF OFF OFF COIN CHUTE#1 COIN CHUTE#2 OFF OFF SERVICE TEST OFF OFF PRESS TEST BUTTON TO EXIT FIG. 7. 5 INPUT TEST 27 7 - 6 OUTPUT TEST Choose OUTPUT TEST to cause the following lower screen to appear. In this test, check the status of each lamp. OUTPUT TEST SELECT LAMP (UP) SET LAMP SELECT LAMP (DOWN) OFF OFF OFF Pressing the TEST BUTTON causes "ON" to be displayed and the corresponding lamp lights up. Pressing the TEST BUTTON again cuases "OFF" to be displayed and the lamp goes off. The Foot Controller is locked with the Slide Lock in the ON status, and Unlocked to become free with the Slide Lock in the OFF status. [. . . ] 105-5218 105-5219-91 833-13204 839-0949-01 260-0055 DESCRIPTION SHIELD CASE SHIELD CASE LID GAME BD SPW FLT BD C-CRX SPW FAN MOTOR DC 5V 65 ASSY PTV (SPW-1200) ITEM NO. SPW1-1220 MGL-1150 RAL-0501 200-5639-SPW DESCRIPTION ASSY BILLBOARD ASSY MASK MASK HOLDER ASSY PROJECTION DISPLAY US SPW 66 ASSY MASK (MGL-1150) ITEM NO. MGL-1102 MGL-1151 MGL-1152 DESCRIPTION TV MASK SLIT PLATE MASK SIDE HOLDER 67 ASSY BILBOARD (SPW1-1220) ITEM NO. SPW-1221 SPW-1222 SPW-1223 SPW-1224 423-0303-91 280-5308 LOCAL PURCHASE DESCRIPTION LEFT COVER RIGHT COVER BILLBOARD BOX BILLBOARD HOLDER BILLBOARD PLATE SPW SPACER 4. 5-12X2 ASSY FL 20W EX W/CONN HIGH T CE 68 ASSY REAR CABI (SPW-3000) 69 ASSY REAR CABI (SPW-3000) ITEM NO. [. . . ]