User manual SEGA WCCF

[. . . ] Refer to the separate Owner's Manual for details of mechanical and hardware issues. In the unlikely event that the product does not function correctly, DO NOT allow anyone other than a technician to touch the internal system. Turn off the power to the machine, making sure to unplug the electrical cord from the outlet, and contact the office listed below or the point-of-purchase for this product. Site maintenance personnel: Activities to be carried out by site maintenance personnel: Other qualified professionals: Activities to be carried out by other qualified professionals: BEFORE USING THE PRODUCT, BE SURE TO READ THE FOLLOWING: To maintain safety: To ensure the safe operation of this product, be sure to read the following before usage. The following instructions are intended for the users, operators and the personnel in charge of the operation of the product. [. . . ] (Only for the machines which use fuses. ) Using fuses exceeding the specified rating can cause a fire and an electric shock. Indicates that mishandling the product by disregarding this caution will cause a slight hazardous situation which can result in personal injury and/or material damage. Specification changes (removal of equipment, conversion and addition) not designated by SEGA are not allowed. The parts of the product include warning labels for safety, covers for personal protection, etc. It is very hazardous to operate the product by removing parts and/or modifying the circuits. Should doors, lids and protective parts be damaged or lost, refrain from operating the product, and contact where the product was purchased from or the office herein stated. SEGA shall not be held responsible for any accidents, compensation for damage to a third party, resulting from the specifications not designated by SEGA. Ensure that the product meets the requirements of appropriate Electrical Specifications. Before installing the product, check for Electrical Specifications. SEGA products have a nameplate on which Electrical Specifications are described. Ensure that the product is compatible with the power supply voltage and frequency requirements of the location. Using any Electrical Specifications different from the designated Specifications can cause a fire and an electric shock. Install and operate the product in places where appropriate lighting is available, allowing warning labels to be clearly read. To ensure safety for the customers, labels and printed instructions describing potentially hazardous situations are applied to places where accidents can be caused. Ensure that where the product is operated has sufficient lighting allowing the warnings to be read. If any label is peeled off, apply it again immediately. Please place an order with where the product was purchased from or the office herein stated. When handling the monitor, be very careful. (Applies only to the product with a monitor. ) Some of the monitor (TV) parts are subject to high tension voltage. Even after turning off the power, some portions are still subject to high tension voltage sometimes. Monitor repair and replacement should be performed only by those technical personnel who have knowledge of electricity and technical expertise. Be sure to adjust the monitor/projector properly. (Applies only to the product with a monitor/projector. ) Do not operate the product leaving on-screen flickering or blurring as it is. [. . . ] - Places 7 and 8 in the Regular League 1st Division are relegated, and places 1 and 2 in the Regular League 2nd Division are promoted. (*): Lose the right to re-enter after winning the tournament. If entry conditions are met again after losing the right to enter, another right to enter can be obtained. Note: Special training menus are unlocked when certain conditions are met. Note that bad advice may have a negative effect on a player's morale. Note: Press the START button during a match to switch between vertical and horizontal screen display. Press the DATA button to switch display of team parameters ON or OFF. Note: If the Player Cards that have been placed on the pitch do not meet the regulations, the game will not proceed to the next sequence (includes instances when time runs out). Note: The satellite with the CPU team will display a standby screen, and the satellite cannot be used until the tournament (in a 1 tournament setting) finishes. Note: At the continue screen, there must be a response from every terminal before the next sequence will occur. 2. The settings for the entire system can be changed from any single place in the network. <<SYSTEMSETTING>> LANGUAGE ENGLISH COMMENTATOR ENGLISH CURRENCY DOLLAR LOCAL CHAMPIONSHIP STYLE TOURNAMENT 8 GAME MODE NORMAL REGULATION FREE POINTS 1300 USE RETIRED CARD ENABLE SET COMPETITION SCHEDULE SAVE DATA CLEAR -> EXIT SELECT WITH SERVICE BUTTON AND PRESS TEST BUTTON Note: For all settings, the final shall be played against the previous winning team (CPU). Note: 16 Player Cards must be registered. [. . . ]