User manual SEIKO SHA

[. . . ] 4 Turn until the desired date appears. * Turn Crown to advance Hour and Minute hands. 10 5 Turn to set the time. 6 Push back in to normal position. English s TIME/CALENDAR SETTING FOR MODELS WITH DAY AND DATE CALENDAR CROWN 1 Pull out to the first click. 2 Turn to show the previous day's date. [. . . ] 3 Turn in the opposite direction to show the previous day of the week. 5 Turn until the desired date and day appears. WED 8 3 * Turn Crown to advance Hour and Minute hands. 6 Turn to set the time. 7 Push back in to normal position. Notes on time setting: 1 When setting Minute hand of a quartz watch, advance it a few minutes ahead and then turn it back to the exact time. 2 If your watch has three hands, pull out Crown all the way when Second hand points at 12 o'clock. After adjusting the time, push Crown back in to normal position in accordance with a time signal for "00" seconds. Notes on calendar setting: 1 The date will change gradually between 9:00 P. M. Therefore, do not change the calendar during this time period. If it is necessary to set the calendar during that time period, first change the time to any time outside it, set the calendar and then reset the correct time. 2 If your watch has a bilingual day calendar, choose the desired language. If used in sea water, rinse the watch in fresh water and dry it completely. · When taking a shower with the water resistant 5 bar watch, or taking a bath with the water resistant 10, 15 or 20 bar watch, be sure to observe the following: * Do not operate the crown when the watch is wet with soapy water or shampoo. * If the watch is left in warm water, a slight time loss or gain may be caused. This condition, however, will be corrected when the watch returns to normal temperature. 5 bar WR 10/15/20 bar WR 7 * Pressure in bar is a test pressure and should not be considered as corresponding to actual diving depth since swimming movement tends to increase the pressure at a given depth. Care should also be taken on diving into water. ** We recommend that you wear a PULSAR Diver's Watch for scuba diving. TEMPERATURES MAGNETISM 8 [for analogue quartz The watch will be +60°C watch only] adversely affected by Your watch works with strong magnetism. Keep -10°C stable accuracy within a it away from close contact S N temperature range of 5° with magnetic objects. (In C and 35° C (41° F and 95° F). the case of a quartz watch, normal Temperatures over 60° C or 140° F accuracy will return if the watch is (50° C or 122° F for some calibres) moved away from the magnetic field) may cause battery leakage or shorten the battery life. [. . . ] the case of a quartz watch, normal Temperatures over 60° C or 140° F accuracy will return if the watch is (50° C or 122° F for some calibres) moved away from the magnetic field) may cause battery leakage or shorten the battery life. CARE OF CASE AND BRACELET Do not leave your watch in very low temperatures below ­10° C or +14° To prevent possible rusting F (-5° C or +23° F for some calibres) of the case and bracelet for a long time since the cold may caused by dust, moisture cause a slight time loss or gain. and perspiration, wipe However, the above conditions will them periodically with a be corrected when the watch returns soft dry cloth. [. . . ]