User manual SEIKO V145

[. . . ] * If it is necessary to set the date during that time period, first change the time to any time outside it, set the date and then reset the correct time. 2 When setting Hour hand, check that AM/PM is correctly set. * The watch is so designed that the date changes once in 24 hours. Turn the hands past the 12 o'clock marker to determine whether the watch is set for the A. M. [. . . ] a) Normal position : Free b) First click : Date setting c) Second click : Time setting 700 1, 000 Light source 60-watt incandescent light Fluorescent light Environment A Distance of 60 cm (2 ft. ) Office, overhead Time required (approx. ) B C 15 hours 11 hours 6 hours 2 hours 80 minutes 30 minutes 30 minutes 8 minutes 60 minutes 50 minutes 30 minutes 10 minutes 6 minutes 3 minutes 3 minutes 1 minute TO PREVENT THE ENERGY DEPLETION s Wear the watch so that it is not covered by your clothes. s When the watch is not in use, leave it in a bright place as long as possible. * Make sure that the watch temperature does not exceed 50° C. 250 hours 175 hours 120 hours 40 hours 22 hours 10 hours 10 hours 3 hours Diver's Watch models / Some Regular models Screw lock crown type Rotating bezel Hour hand Minute hand 5, 000 10, 000 10, 000 3, 000 Distance of 70 cm 30-watt fluorescent light (2 ft. 4 in. ) Distance of 20 cm 30-watt fluorescent light (8 in. ) Distance of 12 cm 30-watt fluorescent light (5 in. ) Distance of 3 cm 30-watt fluorescent light (1 in. ) Sun Sun Cloudy weather Fair weather NOTE ON POWER SUPPLY q This watch is provided with a rechargeable battery for exclusive use with the watch. Unlike conventional battery-powered watches, therefore, battery replacement is not necessary. q The solar cell is a clean energy source, having no adverse effect on the natural environment. 50 a 2 b c d CROWN 100, 000 40 SOLAR DIVERS 200M A: for full charge Date B: for 1-second intervals C: to maintain 1-day usage Second hand The solar cell is installed under the dial. a) b) c) d) Screwed-in position Normal position : Free First click : Date setting Second click : Time setting The values in this column represent the charging times required until Second hand moves constantly at 1-second intervals after the watch starts operating with Second hand moving at 2-second intervals. Even if the watch is not charged for the time specified in the column, Second hand may temporarily move at 1-second intervals. But, it will soon resume moving at 2-second intervals, and therefore, charge the watch for more than the specified period. CAUTION q Never insert a conventional silver oxide battery in your watch as it may explode, generate an intense heat or catch fire. The watch is so designed that even if the battery is installed in the watch, the watch will not operate. q The above table provides only a general guideline. q When the watch is fully charged, it will keep operating for approximately 6 months. 30 3 When the watch is charged after it has completely stopped, set the date and time before wearing the watch. 8 2 Keep the watch exposed to the light until Second hand moves at 1-second intervals. 7 3 Yes No No No 5 bar Yes Yes No No * The rotating bezel turns only counterclockwise for safety's sake. 10/15/20 bar Yes Yes Yes No CROWN 1 Unscrew by turning counterclockwise. 3 Turn to set the previous day's date. 4 Pull out to second click when Second hand is at the 12 o'clock position. 6 Turn to set Hour and Minute hands to the desired time. 5 6 7 Push back in to normal position in accordance with a time signal. 8 While pressing, turn clockwise to screw in completely. PRECAUTIONS FOR DIVING for Diver's Watch model Before diving Check that: · the watch operates normally. · the second hand is moving at 1-second intervals. If it is moving at 2-second intervals, do not use the watch for diving. (For recharging the watch, see "HOW TO CHARGE AND START THE WATCH") · the time and date are properly indicated. · the rotating bezel turns counterclockwise smoothly (the rotation must not be too loose or too tight) and the " " mark aligns with the minute hand. · the crown is locked tightly in place. · there are no visible cracks in the crystal or the watch band. · the strap or bracelet is securely fastened to the watch case. · the buckle or clasp keeps the strap or bracelet firmly secured to the wrist. [. . . ] However, the above conditions will be corrected when the watch returns to normal temperature. MAGNETISM Your watch will be adversely affected by strong magnetism. Keep it away from close contact with magnetic objects. CARE OF CASE AND BRACELET To prevent possible rusting of the case and bracelet, wipe them periodically with a soft dry cloth. N S SPECIFICATIONS 1 2 3 4 5 6 Frequency of crystal oscillator . . Driving system . . . . . . . . . . . . . . . . . . . . . . . . . . Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]