Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SEKONIC L-318B DIGILITE. We hope that this SEKONIC L-318B DIGILITE user guide will be useful to you.
Lastmanuals help download the user guide SEKONIC L-318B DIGILITE.
Manual abstract: user guide SEKONIC L-318B DIGILITE
Detailed instructions for use are in the User's Guide.
[. . . ] PREPARING METER FOR OPERATION
Battery check: Place a battery in battery chamber correctly, Then b. c. mark and bar symbols and switch the meter ON are displayed for a second. Number of bar symbols shows degree of battery capacity. [. . . ] For measuring illumination contrast: Mount Lumidisc to swivel head. Switch the meter ON and point Lumidisc directly toward center of main light. Press measuring switch in EV mode and read-out the measured value. In the same manner, read the EV number of fill-in light. Difference between EV numbers of main and fill-in lights becomes contrast ratio (refer to Table 1). For measuring luminance (Lux): Set ISO sensitivity to ISO 100 regardless of your film speed. Place Lumidisc parallel with the measured surface and read EV number in the same manner as for other measurements. As to Lux value corresponding to the measured EV number, please refer to Table 2. Reflected light measurement: Mount Lumigrid to swivel head.
Switch the meter ON and point Lumigrid directly toward part of subject to be measured. Measure reflected light from main point of subject as close as possible to the subject. Use adequate care in this case that the meter shadow does not interfere with the light to be measured. Calculation dependent upon change of film speed can be made by pressing either side of UP/DOWN key while depressing ISO selecting key. Calculation dependent upon change of shutter speed can be made by pressing either side of UP/DOWN key only. Conversion of measuring mode can be made by pressing F/EV selecting key. [. . . ] Optional accessory Viewfinder 5° Measuring range
Table 1
Table 2
Viewfinder 5° By using this viewfinder the 5' spot measurement is available. It makes you possible to measure reflected light of distant subject without going up close to the subject, or to check reflected light from small part of the subject. Measuring range with viewfinder EV 2-EV 1 9. 9/ISO 100
SEKONIC CO. , LTD.
7-24-14, Oizumi-Gakuen-cho, Nerima-ku, Tokyo, Japan Phone (03) 3978-5155 Telex J34376 SEKONIC Fax (03) 3978-5229 Cable SEKONIC TOKYO [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SEKONIC L-318B DIGILITE
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SEKONIC L-318B DIGILITE will begin.
