User manual SENNHEISER ASA 1

[. . . ] 16 Accessories and spare parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Manufacturer Declarations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Thank you for choosing Sennheiser! [. . . ] To fasten the stacking elements: µ Unscrew and remove the four recessed head screws (M4x8). Secure the stacking elements µ to the ASA 1. 7 Putting the ASA 1 into operation Stacking several ASA 1 You can stack the ASA 1 and the receivers on top of each other. Danger of injury due to toppling stacks!Place the stack on an absolutely flat surface. Secure the stack against toppling over. Stack the devices so that the recesses of the stacking elements completely engage with each other. Mounting the ASA 1 into a 19" rack Do not fit the device feet when mounting the ASA 1 into a 19" rack. When installing the device in a closed or multi-rack assembly, please consider that, during operation, the ambient temperature, the mechanical loading and the electrical potentials will be different from those of devices which are not mounted into a rack. The ambient temperature within the rack must not exceed the temperature limit specified in the specifications. When rack mounting, take good care not to affect the ventilation required for safe operation. If necessary, provide additional ventilation. Make sure that the mechanical loading of the rack is even. When connecting to the power supply, observe the information indicated on the type plate. If necessary, provide overcurrent protection. 8 Putting the ASA 1 into operation When rack mounting, please note that intrinsically harmless leakage currents of the individual mains units may accumulate, thereby exceeding the allowable limit value. As a remedy, ground the rack via an additional ground connection. For rack mounting the ASA 1, you require (see "Accessories and spare parts" on page 17): · the GA 3 19" rack adapter Rack mounting one ASA 1 Unscrew and remove the two recessed head screws (M4x8) on one side of the ASA 1. ¹ ¸ ¸ Hold one rack mount "ear" to the ASA 1. Secure the rack mount "ear" ¸ to the side of the ASA 1 using the two recessed head screws. Repeat for the other rack mount "ear" as described above. Secure the blanking plate ¹ to one of the rack mount "ears" ¸ using two recessed head screws (M 6x10). If you do not want to front mount the antennas: Insert the two blanking plugs blanking plate. into the holes of the 9 Putting the ASA 1 into operation If you want to front mount the antennas: Use the optional AM 2 antenna front mount kit (see "Accessories and spare parts" on page 17). If you want to use remote antennas (see "Accessories and spare parts" on page 17): Connect the remote antennas. [. . . ] Additional warranty conditions can be found on our website at www. sennheiser. com under "Service & Support" and "Terms of Warranty". CE Declaration of Conformity This device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The declaration is available at www. sennheiser. com. Before putting the device into operation, please observe the respective country-specific regulations. [. . . ]