User manual SENNHEISER EK 1038

[. . . ] tourguide UHF Instructions for use Contents Contents Important safety instructions . 19 Limiting the volume at the headphone output . 26 SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophones . 31 SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitters . [. . . ] Use a brush or similar to remove dust from the charging compartments. Do not use any cleansing agents or solvents. 25 L 2015 quick charger Suitable transmitters of the evolution wireless series G 2 The EK 1038 bodypack receiver matches any of the transmitters (range E) of the Sennheiser evolution wireless series G 2: Radiomicrophones: SKM 100 G2 / SKM 300 G2 / SKM 500 G2 Bodypack transmitters: SK 100 G2 / SK 300 G2 / SK 500 G2 Plug-on transmitters: SKP 100 G2 / SKP 500 G2 The SK 2015 bodypack transmitter of the 2015 system from the domain of audiology also fits to the EK 1038 bodypack receiver. Note: To put the system into operation, transmitter and receiver must be set to the same frequency! The channel bank system The system is available in the UHF frequency range from 830 to 866 MHz with 1440 transmission frequencies. Transmitters that are to be combined with the EK 1038 bodypack receiver thus have to use the following transmission range: Range E: 830 to 866 MHz The transmitters have nine channel banks with up to 20 channels each. channel 1 Kanal 1 channel bank 8 Kanalbank 1. . . 8 channel 2 Kanal 2 preset frequency Voreingestellte Frequenz preset frequency Voreingestellte Frequenz channel Kanal 20 20 preset frequency Voreingestellte Frequenz channel 1 Kanal 1 channel bank Kanalbank U U channel 2 Kanal 2 freely selectable Frei wählbare Frequenz frequency freely selectable Frei wählbare Frequenz frequency channel Kanal 20 20 freely selectable Frei wählbare Frequenz frequency Each of the channels in the channel banks "1" to "8" has been factory-preset to a transmission frequency (see enclosed frequency table). These transmission frequencies cannot be changed but have 26 L 2015 quick charger been preset so that e. g. country-specific regulations on frequency usage are taken into account. The channel bank "U" (user bank) allows you to store your selection out of 1440 transmission frequencies that are freely selectable within the preset frequency range. Note: The tourguide frequencies are preset on the channel bank "8". 27 SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophones SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophones Delivery includes The packaging contains the following items: 1 radiomicrophone 2 batteries 1 microphone clamp 1 pouch Operating Controls ³ · » ¿ ´ ²¶ º ¾µ ¸ ¹ ¶ ³ Sound inlet basket · Color-coded identification ring for microphone heads green: MD 835 microphone head blue: MD 845 microphone head red: ME 865 microphone head » Body of radiomicrophone ¿ Battery compartment (not visible from outside) ´ Display section ² LC display ¶ Turnable protective cap for operating controls (shown removed) The following operating controls become accessible in turn by turning the protective cap: º SET button ¾ µ button (DOWN) button (UP) ¸ Red LED for operation and battery status indication (ON/LOW BAT) ¹ ON/OFF button MUTE switch 28 SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophones Preparing for use Inserting and changing the battery ´ » For powering the radiomicrophone, you can either use two 1. 5 V AA size batteries or the rechargeable Sennheiser BA 2015 battery pack. Unscrew the display section ´ from the radiomicrophone's body » by turning it counter-clockwise. Slide back the display section ´ as far as it will go. Insert the 9 V PP3 alkaline battery (IEC 6 LR 61) or the BA 2015 accupack. Please observe correct polarity when inserting the battery. Close the battery compartment cover . ´ Push the battery compartment into the radiomicrophone's body. Note: For rechargeable battery operation of the receiver, only use the BA 2015 rechargeable battery In order to ensure optimum operational reliability. For charging the accupack, only use the L 2015 charger. Both the rechargeable battery and the charger are available as accessories. The rechargeable battery is fitted with an integrated sensor which is ­ via a third contact ­ monitored by the electronics of the receiver and the charger. The sensor is necessary for the following control purposes: The taking into account of the different voltage characteristics of primary cells (batteries) and accupacks. The battery status indications on the displays, the transmission of transmitter battery status information to the rack-mount receivers and the switch-off thresholds at the end of the operating time are corrected correspondingly. Due to the missing sensor, individual rechargeable battery cells will not be identified as accupacks. The monitoring of the rechargeable battery temperature during charging in the L 2015 charger. [. . . ] If you wish to file a claim under the warranty, please send the product to your local service partner, together with accessories and proof of purchase. The customer bears the risk of shipment. To avoid any damage in transit, please use the original packaging if possible. An up-to-date list of all service partners of Sennheiser electronic GmbH & Co. [. . . ]