User manual SENNHEISER EMP 2015

[. . . ] Over half a century of accumulated expertise in the design and manufacture of high-quality electro-acoustic equipment have made Sennheiser a worldleading company in this field. We have designed this product to give you reliable operation over many years. Please take a few moments to read these instructions carefully, as we want you to enjoy your new Sennheiser product quickly and to the full. This part of the instruction manual contains a detailed and complete description of the system. [. . . ] During operation, the ends of the loudspeaker cables must never come into contact. This can cause a short circuit and may damage your speaker. Connect two loudspeakers to each loudspeaker output . You can connect sound recording devices (e. The connected device records the same signal that can be heard in the room through the loudspeakers. If possible, connect the sound recording device via its line input (LINE IN, REC. For correct connection of the different audio devices, please refer to the diagrams at the left. Adjusting the recording level The recording level is independent of the setting of the volume controls · and ». It is, however, dependent on the setting of the line input sensitivity control (LINE IN) µ. control µ adjusts the input level of the connected audio device. The recording level of the line output can be adjusted from 0 to 700 mVrms (corresponds to minus infinite to up to 0 dBU). The sound recording device is connected via its line input (LINE IN, REC. IN, AUX IN, TB IN or similar): Turn control ¸ clockwise as far as possible and adjust the input level of the sound recording device. The sound recording device is connected via its microphone input: Set the input level of the sound recording device to maximum and use control ¸ to adjust the recording level so that, during loud passages, distortion is avoided. Note: If control ¸ is turned counterclockwise as far as possible, no audio signal will be available at the line output . If you have connected two mono sound recording devices, the control adjusts the recording level of both devices. With one Soundfield System, up to three speakers can speak simultaneously in the same room. For installing the system described above, you require additional SK 500 bodypack transmitters and EM 500 rack-mount receivers (u "Recommended accessories"). Connecting an EM 500 receiver For connecting an EM 500 receiver, you require a connecting cable fitted with an 1/4" (6. Observe a minimum distance of 50 cm between the receiving antenna and metal objects (such as cross members or reinforced-concrete walls). With the Soundfield System, all necessary adjustments to the transmitter and receiver section settings can be made by using the SET and and buttons. the settings are indicated on the respective displays. [. . . ] The display then switches back to the standard display. Note: Use the same channel number for both transmission and receiving frequency!After you have finished your entries, you can lock the buttons on the transmitter and the receiver section to prevent accidental programming or turning off during operation. Activating the lock mode Press the SET button five times to select the "Loc" menu. [. . . ]