User manual SENNHEISER EW 122-P G3

[. . . ] 100 Series Instruction manual Contents Contents Important safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Receiver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Bodypack transmitter and radio microphone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Protection rings in different colors are available as accessories. The protection rings allow you to clearly identify each radio microphone. Remove the color-coded protection ring as shown in the left-hand diagram. Put on a new protection ring as shown in the right-hand diagram. 16 Using the devices º º Using the devices To establish a transmission link, proceed as follows: 1. The transmission link is established and the receiver's RF level display "RF" reacts. If you cannot establish a transmission link between transmitter and receiver: Make sure that transmitter and receiver are set to the same frequency bank and to the same channel. If necessary, read the chapter "If a problem occurs . . . " on page 28. It is vital to observe the following notes: Make sure that the desired frequencies are listed in the enclosed frequency information sheet. Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license. Switching the devices on/off EM 100 receiver To switch the receiver on: 00MHz 00 G3 SET Briefly press the STANDBY button ². The receiver switches on and the "Receiver Parameters" standard display appears. ² To switch the receiver to standby mode: If necessary, deactivate the lock mode (see page 21). Keep the STANDBY button ² pressed until "OFF" appears on the display panel. When in the operating menu, pressing the STANDBY button ² will cancel your entry (ESC function) and return you to the current standard display. 17 Using the devices To completely switch the receiver off: Disconnect the receiver from the mains by unplugging the mains unit from the wall socket. SK 100 bodypack transmitter ¿ ¸ ¸ µ To switch the bodypack transmitter on (online operation): Push the two catches ¸ and open the battery compartment cover µ. ON/OFF Briefly press the ON/OFF button . The bodypack transmitter transmits an RF signal. The red ON LED ¿ lights up and the standard display "Frequency/Name" appears on the display panel. You can switch the bodypack transmitter on and deactivate the RF signal on switch-on. For more information, see below. To switch the bodypack transmitter off: If necessary, deactivate the lock mode (see page 21). ON/OFF Press the ON/OFF button until "OFF" appears on the display panel. The red ON LED ¿ goes off and the display panel turns off. When in the operating menu, pressing the ON/OFF button will cancel your entry (ESC function) and return you to the current standard display. To switch the bodypack transmitter on and to deactivate the RF signal on switch-on (offline operation): ON/OFF Press the ON/OFF button until "RF Mute On?" appears on the display panel. SET Press the SET button ¶. The transmission frequency is displayed but the bodypack transmitter does not transmit an RF signal. The transmission icon is not displayed. 18 Using the devices 543. 200 MHz ew100 G3 AF P MUTE Use this function to save battery power or to prepare a bodypack transmitter for use during live operation without causing interference to existing transmission links. To activate the RF signal: ON/OFF SET Briefly press the ON/OFF button . "RF Mute Off" appears on the display panel. The transmission icon is displayed again. SKM 100 radio microphone ¾ ¹ To switch the radio microphone on (online operation): ON/OFF Briefly press the ON/OFF button ¹. [. . . ] 450 g Overall device Temperature range Power supply Nominal voltage Current consumption: · at nominal voltage · with switched-off transmitter Operating time Dimensions Weight (incl. batteries) In compliance with (SK and SKM) Europe: EMC Radio Safety EN 301489-1/-9 EN 300422-1/-2 EN 60065, EN 62311 (SAR) Approved by (SK) Canada: USA: Industry Canada RSS 210, IC 2099A-G3SK limited to 806 MHz FCC-Part 74, FCC-ID: DMO G3SK limited to 698 MHz Approved by (SKM) Canada: USA: Industry Canada RSS 210, IC: 2099A-G3SKMEM limited to 806 MHz FCC-Part 74, FCC-ID: DMO G3SKMEM limited to 698 MHz 33 Specifications Microphones (SK 100) ME 2 Microphone type Sensitivity Pick-up pattern Max. SPL condenser 20 mV/Pa omni-directional 130 dB SPL ME 3 condenser 1. 6 mV/Pa cardioid 150 dB SPL ME 4 condenser 40 mV/Pa cardioid 120 dB SPL Microphone heads (SKM 100) MMD 835-1 Radio microphone type Sensitivity Pick-up pattern Max. SPL dynamic 2. 1 mV/Pa cardioid 154 dB SPL MMD 845-1 dynamic 1. 6 mV/Pa super-cardioid 154 dB SPL MME 865-1 condenser 1. 6 mV/Pa super-cardioid 152 dB SPL Polar diagrams and frequency response curves of the microphone heads (SKM 100) Polar diagram MMD 835-1 30° 0° 0 5 10 60° 15 20 25 90° dB 90° 60° 30° Frequency response curve MMD 835-1 dBV -30 -40 -50 -60 120° 120° -70 -80 50 100 200 500 1k 2k 5k 10k 20k 125 Hz 250 Hz 500 Hz 1000 Hz 150° 180° 150° 2000 Hz 4000 Hz 8000 Hz 16000 Hz Hz Polar diagram MMD 845-1 30° 0° 0 5 10 60° 15 20 25 90° dB 90° 60° 30° Frequency response curve MMD 845-1 dBV -30 -40 -50 -60 120° 120° -70 125 Hz 250 Hz 500 Hz 1000 Hz 150° 180° 150° 2000 Hz 4000 Hz 8000 Hz 16000 Hz -80 50 100 200 500 1k 2k 5k 10k 20k Hz 34 Manufacturer Declarations Polar diagram MME 865-1 30° 0° 0 5 10 60° 15 20 25 90° dB 90° 60° 30° Frequency response curve MME 865-1 dBV -30 -40 -50 -60 120° 120° -70 125 Hz 250 Hz 500 Hz 1000 Hz 150° 180° 150° 2000 Hz 4000 Hz 8000 Hz 16000 Hz -80 50 100 0° 200 90° 500 1k 2k 5k 10k 20k Hz Manufacturer Declarations Warranty Sennheiser electronic GmbH & Co. [. . . ]