User manual SENNHEISER EW 300 IEM

[. . . ] We have designed these products to give you reliable operation over many years. Please take a few moments to read these instructions carefully, as we want you to enjoy your new Sennheiser products quickly and to the full. With the Sennheiser evolution wireless in-ear monitoring system ew 300 IEM (suitable for both stage and broadcast use), musicians, video and sound amateurs, reporters/broadcasters, etc. Can directly monitor the received sound signals without troublesome cables or monitor speakers being required. [. . . ] ⺠"MHZ" (MHz) display. Lights up when the frequency is displayed. EK 300 IEM receiver 8-step level display for audio (AF) signal Alphanumeric main display 8-step level display for incoming RF signal Note: If the operating steps for adjusting the settings via the menu are similar for both devices, only the main display of the SR 300 IEM transmitter is shown. A special feature of the Sennheiser evolution wireless system ew 300 IEM is the similarity of the operating controls of both transmitter and receiver. In stressfull situations, for example on stage or during a live show or presentation, it is important that the devices are easy to operate and that adjustments to the settings can be made quickly and instinctively. Therefore, the necessary operating steps for each device are similar. Important: With the / buttons you can directly switch between the factorypreset frequencies (channel presets). Press the SET button to enter the top menu level: By briefly pressing SET again, you can change to the next menu. One second, the selected menu appears on the display and then the current setting of the menu is indicated. Press the / buttons to adjust the settings of the selected menu: The new setting starts flashing on the display. if you return to the previous setting , the flashing stops. Important: New settings become effective immediately and will be retained in memory on switch-off!: When changing transmitter frequencies, care should be taken to avoid causing interference to other channels/users. in the "TUNE" and "NAME" menu , the / buttons feature a "fast search" function. By briefly pressing the / buttons, the display jumps either forwards or backwards to the next setting. If you hold down a button, the cycling of the display is continously accelerted. If you release the button and start over again, the cycling of the display restarts at normal speed. The "fast search" function allows you to get fast and easily to your desired setting. Press the SET button to return to the top menu level: Have you finished your entries? press the SET button to return to the top menu level. The display then switches back to the standard setting. With the / buttons you can directly switch between the factorypreset frequencies (channel presets). [. . . ] the systems operate exclusively in the UHF band. UHF transmission is extremely reliable and is far less prone to interference than the overcrowded VHF band ­ harmonics from mains units, fluorescent tubes, refrigerators, computers, etc. Also indoor propagation of UHF radio waves is better than VHF so that the RF power can be kept low ­ this is also an advantage when using multi-channel systems. Finally, UHF frequency ranges are being approved all over the world for radiomicrophone usage ­ in some countries licence-free. [. . . ]