User manual SENNHEISER MKE 80 R

[. . . ] "Complete" means that the microphone is a ready far use unlt which is specially intended to work with at often changing recarding places. only the connecting cable has to be added. [. . . ] the condltion of the battery IS checked every time the microphone is sWltched on (red mark visible) ar off. When switching on, a LED (2) lights up, Indicatlng sufficient supply voltage (fig. 20 h left - enough time to optain a new battery. New batteries are avallable from your local dealer. When the microphone is not in use it should be switched off to prevent the battery from belng unnecessarily drained. The microphone can be phantom-powered with DC-voltages between 12. 6 shows the basic Clrcuit diagram lor phantom powering with 48 V. For operation with voltages 01 less than 48 V, the supply voltage resistors in the supply device must lirst be changed over to the values listes in the table below. It primanly picks up sound sources which are directly In Iront 01the microphone (Iig. 4), Therelore, the mlcrophone should be directed in direction to the sound source. Should the microphone malnly be used with battery supply and seldom with phantom powering, the battery can remain in the handgrip/powering module during phantom powering. Do not operate the mlcrophone with empty battery compartment. For reducing interferences caused by (Ior example) lootlall, wind or handling noise the handgrip/powering module leatures a 3-positlon switchable roll off lilter. Position II brings about a roll off 01 7 dB and position 1'1 reduction 0120 dB at 50 Hz (Iig. [. . . ] 1956) Shock mount with %" internal thread, lits to all tripods, desk stands and booms with %" thread. 2157) Cable lar connection 01 microphones wlth 3-pln XLR-3 plug, system Cannon, to balanced rnicrophone inputs with 3-pin screwable socket according to DiN 41 524. [. . . ]