Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SENNHEISER MKH 106T-U. We hope that this SENNHEISER MKH 106T-U user guide will be useful to you.
Lastmanuals help download the user guide SENNHEISER MKH 106T-U.
Detailed instructions for use are in the User's Guide.
[. . . ] Sennheiser electronic introduced A-B powering, which was then standardised in DIN 45595. As with dynamic microphones, only two wires are required to connect the microphone when this powering system is beeing used. [. . . ] Connection to amplifiers with unbalanced inputs In many cases, lor example most tape recorders, the input socket is unbalanced. in this case one side 01 the balanced microphone output has to be grounded. Apart Irom cases where the microphone is be!Ing used lor prolessional studio purposes, this is not critical, as the large output voltage 01 the microphone combined with its low output impedance provides a large signal to noise ratio. Connection to amplifiers with high input sensitivity If the amplifier being used has a very high input sensitivity, i. When it is normally intended for use with dynamic microphones, it can be necessary to reduce the output voltage from the microphone by means of a voltage divider. This should be built into the microphone cable at the amplifier input. By this means the large signal on the microphone cable is maintained up to just before the amplilier, which helps to increase the signal to noise ratio. Connection to amplifiers with defined input impedances Sennheiser studio condenser microphones can be connected directIy to all amplifiers whose input impedance is larger that 200 Ü. Should however the input impedance be smaller than 200 Ü, a resistor of appropriate value should be placed in series with the microphone so that it "sees" at least 200 Ü. The voltage division caused by this series resistor must 01 course be considered. The same method can be used when a higher output impedance 01 the microphone is demanded. In this case again, aseries resistor can be used to provide correct matching. Connection to amplifiers with powering facilities If an appropriate voltage source is available in the amplifier the condenser microphone can be powered directly. [. . . ] Connecting cable KA 7-1 For use with all Sennheiser mierophones with the suffix U. The KA 7-1 is fitted on one end with a Cannon female eonneetor, the other end is free for the eonneetion of the neeessary plug. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SENNHEISER MKH 106T-U
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SENNHEISER MKH 106T-U will begin.
