User manual SENNHEISER MKH 816 P 48 U3

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SENNHEISER MKH 816 P 48 U3. We hope that this SENNHEISER MKH 816 P 48 U3 user guide will be useful to you.

Lastmanuals help download the user guide SENNHEISER MKH 816 P 48 U3.


Mode d'emploi SENNHEISER MKH 816 P 48 U3
Download
Manual abstract: user guide SENNHEISER MKH 816 P 48 U3

Detailed instructions for use are in the User's Guide.

[. . . ] 20000 Hz The original diagram is included with each microphone, measured from 50. Anschluß an Mischpulte und Tonaufzeichnungsgeräte mit Speisemöglichkeit Connection to mixers and recording equipment with built-in microphone power supply Raccordement ades pupitres de melange el des consoles d'enregistrement avec possibllite d'alimentation MKH816P48U3 Connection to mixers and sound recording equipment with powering facilities . The microphone employs the proven RF-principle for low noise, low interference operation. [. . . ] In this case again, aseries resistor can be used to provide correct matching. sennheiser condenser microphones produce relatively high output voltages exceeding 1 volt at maximum sound pressure levels. This has the advantage that even with long cables induced interference signals can be disregarded. Also the internal noise produced by the microphone does not contribute to the total noise level. The microphones are fitted with RF filters which ensure that no high frequency signals from the microphone can effect the external circuitry and that the microphone itself is protected from high frequency disturbance. It is therefore not necessary, even under the most difficult conditions, to take special precautions, such as double screening of the cables or the provision of high frequency filters. Senn heiser condenser microphones are polarised according to DIN standard i. When apressure pulse strikes the capsule Irom the lront, pin 2 goes positive with relerence to pin 3. Equivalent sound pressure level as per CCIR 468-1 . In this case the microphone is simply connected via apower supply, e. II the microphone is powered bya corresponding supply unit and is to be connected to unbalanced inputs it is generally necessary to use a translormer. The secondary 01 this audio-translormer may then be connected - one side grounded - to the input Proper voltage matching is achieved by selecting a suitable translormer ratio. II the powering adapter MZA 14 P 48 or the power supply unit MZN 16 P 48 is used a translormer is not required. 1 : ground, housing; supply (-) 2: audio (+); supply (+) 3: audio (-); supply (+) according to lEe standard publication 268-14/2 . [. . . ] 1241) Power supply unit for 48 V phantom powering according to DIN 45596. Two microphones can be powered simultaneously from each supply unit Dimensions: 168 x 120 x 50 mm. Further information you will find in the Sennheiser catalogue. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SENNHEISER MKH 816 P 48 U3

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SENNHEISER MKH 816 P 48 U3 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag