User manual SENNHEISER RS 170

[. . . ] Digital Wireless System Instruction manual RS 170 Contents Contents Important safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 The RS 170 digital RF headphone system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Delivery includes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Product overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Observe correct polarity when inserting the batteries. Secure the ear pads » to the ear cups. 16 Putting the RS 170 into operation Charging the headphones' rechargeable batteries CAUTION Danger of damage to the headphones!If standard batteries are inserted into the headphones and you place the headphones on the headphone holder/charger of the transmitter, the batteries can leak and damage your headphones. Only place the headphones on the headphone holder/ charger of the transmitter if rechargeable batteries are inserted. Charge the rechargeable batteries for at least 16 hours prior to first time use. Subsequent charging time is about half of the previous operating time. The operating time is up to 24 hours. 16h 5 HDR 170 1 Place the headphones on the headphone holder/charger of the transmitter. Make sure that the headphones make good contact with the charging contacts . The rechargeable batteries are being charged. When the rechargeable batteries are fully charged, the CHARGE LED goes off. Always store the headphones on the headphone holder/charger to ensure that they are fully charged when they are needed. Adjusting the headband of the headphones ³ For good sound quality and best possible comfort, the headband has to be adjusted to properly fit your head. To do so, adjust the headband ³ via its snap-in locking mechanism: HDR 170 Wear the headphones so that the headband ³ runs over the top of your head. Adjust the length of the headband so that ­ your ears are completely inside the earpads, ­ you feel even, gentle pressure around your ears, ­ a snug fit of the headband ³ on the head is ensured. 17 Using the RS 170 Using the RS 170 To switch the product on and to listen to your sound source, proceed as follows: Sequence of steps 1. Make sure that the rechargeable batteries are charged. Page 17 ­ 20 20 21 Switching the transmitter on and off Switching the transmitter on Press the multi-function button for approx. The multi-function button green, indicating that the transmitter is in enrollment mode. flashes 1s 5s Once the transmitter has found suitable headphones, it pairs with the headphones and transmits an audio signal. The multi-function LED µ of the headphones and the multi-function button of the transmitter flash slowly. µ 4 18 Using the RS 170 Switching the transmitter off Press the multi-function button for approx. To disconnect the transmitter from the mains: Pull out the mains plug from the wall socket. Please note that In this case, the headphones' rechargeable batteries will not be recharged. If the headphones are outside the transmission range or switched off for more than 5 minutes, the transmitter automatically switches to standby mode. In standby mode, the transmitter's power consumption is very low so that it can remain connected to the mains. 19 Using the RS 170 Switching the headphones on and off WARNING Danger due to high volumes!Listening at high volume levels for long periods can lead to permanent hearing defects. [. . . ] WEEE Declaration Your Sennheiser product was developed and manufactured with highquality materials and components which can be recycled and/or reused. This symbol indicates that electrical and electronic equipment must be disposed of separately from normal waste at the end of its operational lifetime. Please dispose of this product by taking it to your local collection point or recycling centre for such equipment. This will help to protect the environment in which we all live. 33 Manufacturer declarations Statements regarding FCC and Industry Canada FCC Declaration of Conformity (DoC) SENNHEISER Model No: RS 170 We, Sennheiser Electronic Corporation Strat. [. . . ]