User manual SENNHEISER SI 1013

[. . . ] Because of the cable grip, the connector cannot slip out of the socket and interrupt operation. note A cable grip is particularly important when the device is permanently rack mounted. [. . . ] note A cable grip is particularly important when the device is permanently rack mounted. Inside the rack there are often a large number of cables ­ a cable grip prevents the cables from pulling each other out. The SI 1013 can be rack mounted into 1 U of a 19" rack by using accessories GA 1031-AM or GA 1031-CC. the GA 1031-CC is a blank module to bring the SI 1013 to full 19" width , the GA 1031-AM is identical but has additional BNC sockets to bring outputs ¾ and to the front panel. The rack mountings are supplied with the SI 1013. SZI 1015 Number of transmitting diodes Average radiating power Wavelength of radiated infra-red light Carrier frequency range RF input level Inputs / outputs Threshold voltage for automatic on/off function Operating voltage Current consumption Stand-by Dimensions in mm Weight For the AF connection, use a standard XLR-3 connection cable of the required length. Note: "IR Planning Brochure" from Sennheiser Information on the many possible areas of application of Sennheiser infra-red audio transmission systems can be found in the "IR Planning Brochure". This brochure gives detailed information on infra-red transmission technology and contains application examples as well as possible product combinations and overviews for infra-red system planning. Since we are continually trying to improve our products it may happen that technical alterations are made on the described products after this manual has gone to press. Plug-in mains unit 100 ­ 240 V AC without switching 29 V DC 1. [. . . ] Since we are continually trying to improve our products it may happen that technical alterations are made on the described products after this manual has gone to press. Plug-in mains unit 100 ­ 240 V AC without switching 29 V DC 1. [. . . ]