Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SENNHEISER SI 1019 A. We hope that this SENNHEISER SI 1019 A user guide will be useful to you.
Lastmanuals help download the user guide SENNHEISER SI 1019 A.
Detailed instructions for use are in the User's Guide.
[. . . ] the SIK 1019 A is available in 12 versions according K 11, which are named behind the designation Its tunction is to process sound signals in the way that they can be transmitted to a multi-channel receiver through invisible intrared light. Can be changed, if necesary, to the rear. As the AF-connections are accessible on the rear wiring board the electrical connection is easily done. [. . . ] Power supply module SIS 1019 A 20 This module delivers the power required tor the channel modules as weil as tor the SZI1 019 radiators. Its section tor the channel modules is split up into!In addition to the stabilizer stages, the SIS 1019 A 20 has an RF master amplitier which mixes the signals trom the channel modules and amplities them up to the level required by the intrared radiators. Ex works the chassis is prepared lor operation at 220 VI 50 - 60 Hz. Its power requirements are 32 V 11 A whlch are supplied by the contra I transmitter. The power supply module can supply one radiator. II more than one radiator IS to be connected the power supply unlt GZN 1019-1 * must be used. The modulated RF-signal with a level 012 Vpp (source impedance 60 Q) is available at RF-output sockets @ and @. They are decoupled lram each other and connected in parallel. The signal is looped Irom the lirst radiator to the second, lram the second to the third etc. Cable length between the transmitter and the last radiator shouldn't exceed 1500 m. II the cable length IS more than 300 m the output 01the last radiator has to be terminated with 50 Q in order to prevent standing waves. After all cable connections modules with switch CD. Note: Unused channel modules should be sWltched off, as in multi-channel units the total radiation power is splitted evenly between all channels. [. . . ] The module which makes the LED light up has to be replaced or repaired. For enlarging an existing 9-channel-system to 12 channels a second chassis SIC 1019 A 20, apower supply module SIS 1019 A 20, three channel modules SIK 1019 A and six cover plates SIB 1019 are necessary. Both chassis are to be linked by interconnecting the L sockets @ of both units. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SENNHEISER SI 1019 A
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SENNHEISER SI 1019 A will begin.
