User manual SENNHEISER SK 2013

[. . . ] The plug is disconnected by unscrewing the threaded collar. The voltage necessary to operate these microphones is available at the microphone input of the transmitter. Dynamic microphones and other low-impedance sources can be connected through an external coupling condenser of approx. 10 µF (+pole on contact 2). 4. 4. 1. USING FOR THE FIRST TIME B 50 / B 250 QUICK-CHANGE ENERGY PACK Insert the batteries as described on page 22, Fig. [. . . ] After insertion of the batteries, the cover of the quick-change energy pack is to be snapped into place. The LED display on the front side of the energy pack (Fig. 1) serves as a battery control display. FIG. 1 BATTERY CONTROL DISPLAY 100 % 50 % 10 % STARTS TO BLINK IF THE REMAINING OPERATING TIME FALLS BELOW. 3 QUICK-CHANGE ENERGY PACK B 50 QUICK-CHANGE ENERGY PACK B 250 + + + + + CLOSE COVER NOTE: ALKALINE-MANGANESE BATTERIES OF THE "MIGNON" LRC AA TYPE ARE TO BE USED EXCLUSIVELY. PERFECT FUNCTIONING OFTHE TRANSMITTER IS GUARANTEED ONLY WITH THIS TYPE OFBATTERY. 22 4. 2. BA 50 / BA 250 QUICK-CHANGE ENERGY PACK The LCD display on the front side of the energy pack (Fig. 4) servers as a battery control display. FIG. 4 RECHARGEABLE BATTERY DISPLAY 100 % 80 % 60 % 40 % 20 % STARTS TO BLINK IF THE REMAINING OPERATING TIME FALLS BELOW 30 MIN. In addition to the visual display on the quick-change energy pack, the transmitter communicates the status of the batteries or the rechargeable batteries to the EM 1046 for presentation on the receiver display. FIG. 5 RELEASING THE QUICK-CHANGE ENERGIE PACK Squeeze the catch with the thumb and index finger, and separate the transmitter from the quick-change energy pack. To attach the quick-change energy pack, simply let the quick-change energy pack snap into the transmitter. 23 4. 3. 260 MHz SK 50 VHF (1) 22 MHz SK 50 VHF (2) 28 MHz SK 50 VHF (3) 28 MHz SK 50 VHF (4) 28 MHz SK 50 VHF (5) 37 MHz ± 10 ppm < 4 nW FM ± 40 kHz / ± 56 kHz Sennheiser HiDyn plus 13 mV - 1. 55 V 8-position switch 70 Hz - 20 kHz 110 dB(A) eff. < 0. 3 % (nominal peak / 1 kHz) AF: Lemo special (3-pin) RF: Lemo special Koax 94 x 60 x 17 mm with B 50 / BA 50 116 x 60 x 17 mm with B 250 / BA 250 approx. 230 g with B 250 / BA 250 50 mW / -2 dB B 50: > 6 h B 250: > 13 h BA 50: > 4 h BA 250: > 6. 5 h 1 1 1 1 SK 50 VHF body-pack transmitter marking set antenna (aligned) instructions for use Switching band width Frequency stability Spurious and emmissions Modulation Nominal / peak deviation Compander Input sensitivity for peak deviation Audio frequency range Dynamics THD Connections Dimensions with power pack Weight with power pack RF output power Operating time with primary cells Operating time with rechargeable battery Delivery includes 28 11. TECHNICAL DATA Transmit frequencies Frequency range SK 2013 VHF 16 SK 2013 VHF (1) 138 . . . 260 MHz SK 2013 VHF (1) 38 MHz SK 2013 VHF (2) 55 MHz SK 2013 VHF (3) 50 MHz ± 10 ppm < 4 nW FM ± 40 kHz / ± 56 kHz Sennheiser HiDyn plus 13 mV - 1. 55 V 8-position switch 70 Hz - 20 kHz 110 dB(A) eff. < 0. 3 % (nominal peak / 1 kHz) AF: Lemo special (3-pin) RF: Lemo special Koax 116 x 60 x 17 mm with B 250 / BA 250 approx. 230 g with B 250 / BA 250 250 mW / -1 dB B 50: cannot be used B 250: > 2. 5 h BA 50: cannot be used BA 250: > 2. 5 h 1 1 1 1 SK 2013 VHF body-pack transmitter marking set antenna (aligned) instructions for use Switching band width Frequency stability Spurious and emmissions Modulation Nominal / peak deviation Compander Input sensitivity for peak deviation Audio frequency range Dynamics THD Connections Dimensions with power pack Weight with power pack RF output power Operating time with primary cells Operating time with rechargeable battery Delivery includes Erros and omissions excepted. 29 KONFORMITÄTSERKLÄRUNG Sennheiser electronic GmbH & Co. KG, Am Labor 1, D-30900 Wedemark erklären, daß dieses Gerät den einschlägigen Anforderungen der EG-Richtlinie 89/336/EWG entspricht. Zur sachgemäßen Umsetzung der in den EG-Richtlinien genannten Anforderungen wurden folgende Normen herangezogen: ETS 300 445 ETS 300 422 Bemerkung: Vor Inbetriebnahme sind die jeweiligen länderspezifischen Vorschriften zu beachten! CERTIFICATE OF CONFORMITY Sennheiser electronic GmbH & Co. [. . . ] KG, Am Labor 1, D-30900 Wedemark erklären, daß dieses Gerät den einschlägigen Anforderungen der EG-Richtlinie 89/336/EWG entspricht. Zur sachgemäßen Umsetzung der in den EG-Richtlinien genannten Anforderungen wurden folgende Normen herangezogen: ETS 300 445 ETS 300 422 Bemerkung: Vor Inbetriebnahme sind die jeweiligen länderspezifischen Vorschriften zu beachten! CERTIFICATE OF CONFORMITY Sennheiser electronic GmbH & Co. KG, Am Labor 1, D-30900 Wedemark declare that this device conforms to the basic requirements of EEC Directive 89/336/EEC. To effect correct application of the requirements stated in the EEC Directives, the following standards were consulted: ETS 300 445 ETS 300 422 Important: Before putting the device into operation, please observe the respective country-specific regulations! DÉCLARATION DE CONFORMITÉ Sennheiser electronic GmbH & Co. [. . . ]