User manual SENNHEISER SK 1010-6

[. . . ] Ional characteristic and features low handling noise sensitivity. It is to be preferred when several people speak from different directions into the same microphone. In noisy environments, reverberant rooms or when there is a danger of acoustical feedback, we recommend using the screw-in microphone MKE 4010 with a cardioid directional charactenstic. [. . . ] Please remember that whenever the transmitter is hand-held the windscreen MZW 4012 A included in the screw-in microphones packaging should be used. iI overmodulation still occurs when the rated swing is reached the controlled amplilier will switch on. This enables a distortion-Iree transmission even when the modulation range is grossly exceeded. This mode does, however, have the slight drawback that "breathing" noises (typlcal lor every controlled amplilier) must be expected. In cases where the transmitter is being used together with a hall PAsystem please ensure that the sensitivity control 0 is not used to adjust the volume. The volume adjustment should be exclusively carried out on the PA-system's amplilier and should be so adjusted that there is an ample range available belore the leedback level is reached. II noticeable distortion occurs when the transmitter is correctly adjusted then the problem is in the overloading 01 the input stage 01 the PA-amplilier, caused by the relatively high output signal (1. II this is the case it is recommended that a suitable attenuated signal should be taken lrom the receiver output. Another way 01wearing the SK 1010 is the use Important information: The wiring arrangement of the input socket was chosen in such a way that the transmitter may be remote-controlled from an external switch. Therefore, the operating voltage lead was interrupted and led across socket contacts 6 and 7. The transmitter may be accordingly only opera ted when this interruption is rejoined via a wire bridge in the microphones. The Identilication sticker CDIn the battery compartment contains the transmission Irequency designation and the licence number, which are required when applying lor a Ilcence to operate your transmitter. 4: beside the microphone and microphone socket respectively you will lind a small operatmg panel wlth the sWltch CD, wo LEDs @ and @ and the sensitivity t control 0. In the position "Off" the unit is completely inoperative. II the operation switch IS put into position "Test", Ilrst the green LED @wililight up il the battery voltage IS more than 6 V. Proper operation can be expected il this control diode lights up brightly. II this diode glows only dimly the battery should be changed or the accumulator charged. control 0 enables the sensitivity 01the transmitter to be changed. [. . . ] II an accumulator is used instead 01 dry batteries - Le. Tr 7/8) can be easily charged using the automatic charger SZL 1010 (Iig. II any delect occurs, the antenna may be unscrewed slot @ with a small screwdriver. [. . . ]