User manual SERATO TTM 57SL V1.8.0

[. . . ] 1xxxx SCRATCHLIVE TTM 57SL OPERATORS MANUAL 1. 8. 0 Important Safety Instructions 1. Install in accordance with manufacturer's instructions. Do not install near any heat sources such as radiators, registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or groundingtype plug. [. . . ] The range is set by the first two taps, after that you can switch to any steady rhythm you feel comfortable with ­ quarter notes, half note, whole notes. Esc resets the BPM, Enter saves the BPM to the track. Your CD player or turntable's pitch slider doesn't need to be at zero, we do the math for you. You can also use the tempo tapper when no song is loaded, for finding the BPM of regular records, for example. Key Lock When Key Lock is on, the key or pitch of the song stays locked at what it would be if the track was playing at normal speed, regardless of the platter speed of the turntable or CD player. Key Lock has scratch detection, so that it automatically turns off when scratching for a natural scratching sound. Turn Key Lock on or off by pressing the button to the top right of the Virtual Deck. Tip: F5 and F10 will turn Key Lock on and off for the left and right decks respectively. Tracking indicator The tracking indicators on the main screen show the quality of the signal coming from the control record or CD. The length of the bar indicates the speed of the record or CD. The color indicates the amount of position information Scratch LIVE is receiving. When you are playing the record at normal speed, the tracking indicator should be grey. If it is mostly red there is a problem reading the control signal. Make sure your needles are clean, and check the calibration in the setup screen. Note: it is normal for the light to be red when cueing or scratching. Autoplay Click the auto button to enable autoplay. With this setting turned on, when one track finishes playing, the next track starts automatically. Load from a crate to play through the songs in that crate, or from your library to play through your library. Use the next | and previous | buttons to jump to the next track or go to the previous track in the list. Autoplay works in both relative and internal modes. Play from start must be checked in the setup screen for autoplay to work correctly. See page 33. 33 / 45 Speeds Set this to match the speed of your turntable for normal playback. Repeat Use the repeat function to repeat the song across the entire length of the control record. [. . . ] Do not bend the torsion spring or touch the sensors. 45 Remove #4 screw Remove #4 screw Torsion spring Mark location before disconnecting ribbon: PGM 1 PGM 2 XFADER Remove ribbon Sensors For more effective cleaning and lubrication, follow the directions outlined below: 1. Required Tool: #1 Philips screwdriver 2. Remove knobs from controls covered by the Lexan faceplate. Remove the four, 4-40 screws attaching the Lexan faceplate. [. . . ]