User manual SEVERIN BR 7961

[. . . ] Never use the vacuum cleaner to pick up - sharp or pointed objects such as glass splinters, - hot ashes, cigarette stubs or chemical matter, - stone dust, plaster, cement or any similar fine dust particles, - foam, water or other liquids. This appliance is not intended for use by any person (including children) with reduced physical, sensory or mental capabilities, or lacking experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Always check the dust bag for any signs of damage before connecting the appliance to the power supply. [. . . ] Should this occur, remove the plug from the wall socket and let the appliance cool down for a minimum of one hour. The vacuum cleaner may then be used again after the blockage has been removed. Carrying handle Always use the handle to carry the appliance. Main power switch with suction power regulator The appliance is switched on and off by pushing the main power switch. Into its storage, press the foot switch of the retract mechanism. Accessories The accessories can be stored in the accessories holder, which attaches to the tube Multi-purpose tool The multi-purpose tool is especially suitable for cleaning large areas. This brush tool is suitable for cleaning uneven areas such as upholstered surfaces, picture frames, rows of books etc. crevice tool The crevice tool is designed to clean difficultto-reach areas such as grooves , niches , corners and crevices. Models with parquet-brush The parquet brush is used for high-grade hard floors such as laminate floors, parquet or ceramic tiles. Changing dust bag or filters Before any filter is changed, always switch the appliance off and remove the plug from the wall socket. the vacuum cleaner uses replaceable filters. When replacing the motor or exhaust-air filter, it may be necessary to cut the filters to size with a pair of scissors. The indicator shows when the dust bag needs changing: as soon as it is permanently illuminated, the dust bag has reached its capacity. The appliance must be switched off before the bag is replaced. Changing the dust bag - Remove the hose from the unit by pressing the two buttons at the end of the hose. - Fit the cardboard frame of the new dust bag into the filter holder. - Push the filter holder back into the filter compartment. - Close the cover of the filter compartment by pressing down lightly until it is heard locking into place. changing the motor-protection filter The motor-protection filter is located at the rear of the filter compartment. Should the filter be visibly dirty, replacement is recommended at the same time as the dust bag is changed. - Lift out the motor-protection filter holder from the filter compartment. - Remove the old motor-protection filter from its holding bracket. [. . . ] Swirl® and Y101® are registered trademarks of a company of the Melitta Group. Anslutning till vägguttaget Se till att nätspänningen i vägguttaget motsvarar den som är märkt på apparatens skylt. - Dra ut sladden till önskad längd (men högst till det röda märket) och sätt stickproppen i vägguttaget. Till att den är avstängd och att den inte är ansluten till vägguttaget. [. . . ]