User manual SEVERIN DAMPFBÜGELAUTOMAT BA 3262

[. . . ] When operating the steam iron, hold only by the handle. Do not allow steam to escape in the direction of anyone nearby. Do not allow the power cord to touch hot surfaces. Do not coil the power cord round the appliance. [. . . ] It should be opened only once the temperature level required for steam ironing (as indicated on the temperature control knob) has been reached. - Open the cover of the water fill hole. - Fill the empty water reservoir using the measuring cup provided. Fill the reservoir to the indicated "Max" level only. General information about ironing Always check first whether a label with ironing instructions is attached to the article to be ironed. Cotton and linen (high temperature) These markings can also be found on the temperature control knob of the steam iron in form of dot symbols. Laundry to be ironed should be sorted according to the fabric ironing temperature. Follow the ironing symbols and start with the lowest temperature. When ironing highly sensitive fabrics, or if you are not sure about the fabrics, you may carefully test-iron at a non-visible point, e. If the laundry is being dried in a dryer before ironing, the temperature should be adjusted to "iron dry". Start up Clean the steam iron before using for the first time, according to the instructions given in the paragraph "General Care and Cleaning". This will result in the removal of possible dust particles from the soleplate and subsequently lessen the smell typically encountered when first switching on. - After filling the reservoir with water, place the steam iron upright on its base stand and insert the plug into the wall socket. Before ironing any fabrics, the soleplate Should be cleaned by passing it over an old, clean cotton cloth, while using the steam jet function; this helps to flush out any dirt residues or lint particles trapped inside the openings in the soleplate. The steam output can be continuously adjusted with the steam control button or completely switched off for dry ironing. For dry ironing, the water reservoir may be empty. Should there be water left in the reservoir, the steam jet function may also be used when dry-ironing at higher temperature settings. Place the steam iron upright on its base stand after use and remove the plug from the wall socket. steam Jet When the steam jet button is depressed , an additional hot steam jet is emitted from the soleplate. This function can be very useful when the regular amount of steam emitted is not sufficient to remove stubborn creases or when ironing difficult or thick fabrics. The steam jet function may also be used with the iron held vertically, to remove creases or wrinkles from fabrics. Using the Spray Nozzle The laundry can be dampened by pressing the spray button. [. . . ] - If necessary, the unit may be wiped with a dry fuzz-free cloth. - Starch, fat and other deposits on the soleplate may be removed with a woollen cloth soaked in a vinegar-water solution. Guarantee This product is guaranteed against defects in materials and workmanship for a period of two years from the date of purchase. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. [. . . ]