User manual SEVERIN KA 5987

[. . . ] Dear Customer Before using the appliance, the user should read the following instructions carefully. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding CE labelling directives. [. . . ] Once the brewing cycle is complete, wait around 30 seconds before removing the filter holder. - Hot-water/steam selector button This selector allows you to choose either hot water or steam. - To dispense hot water, the button must be in its released position. The hot water can now be drawn through either the boiler outlet or the steam outlet. - To dispense steam , the selector button must be pushed in. The steam can be drawn through the steam nozzle using the valve selector control. - Preheating the cups and the filter holder We recommend pre-heating the cups and the filter holder, as this will ensure a higher coffee temperature. - As soon as the operating temperature has been reached, the green temperature indicator light comes on. - Turn the valve selector control to the symbol. - Let the cup(s) fill up to approximately 3 /4, and then turn the valve selector control to its neutral position to switch off the pump. - Put the cup(s) aside to warm up and pour out the water just prior to making espresso. the cups may also be placed on the warming top to pre-heat them. - Filling the filter sieve with ground coffee / removing the coffee grounds - Filling with ground coffee - Remove the preheated filter holder (Caution: the filter holder is hot). - Fill with finely ground coffee: - 1 cup = 1 level measuring scoop - 2 cups = 2 level measuring scoops Note: if the filter holder is overfilled, it will not lock properly under the boiler outlet. - Use the measuring scoop to distribute the ground coffee evenly and press it down lightly. Any excess coffee powder on the rim of the filter holder must be removed. - Removing the used grounds - After the brewing cycle is complete, wait approximately 30 seconds until the operating pressure has been sufficiently reduced. - Exercise caution when removing the filter holder: it may still contain some hot water. Please note that, when preparing 2 cups of espresso, slightly more water will remain on the espresso grounds. - To remove the coffee grounds, gently tap the side of the filter holder against a vertical surface. Ensure that the paper rim of the ESE pad does not protrude over the rim of the filter sieve. - Removing the used espresso pad: - After the brewing cycle is complete, wait for approximately 30 seconds until the operating pressure has been sufficiently reduced. [. . . ] - Push the hot-water/steam selector button in. - Place the jug with the milk under the milk frother. - Turn the valve selector control to the position. Steam will now be emitted from the nozzle. [. . . ]