User manual SEVERIN KB 8876

[. . . ] Dear Customer, Before using the appliance, read the following instructions carefully and keep this manual for future reference. The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. [. . . ] If the unit has been tilted more than 30° during transport, allow it to stand upright for at least 4 hours before it is connected to the mains. When the unit is first switched on, a slight `new' smell may be noticed. However, this will disappear once the cooling process has begun. Installation The appliance should be set up in a well-ventilated, dry room. It should be operated in conditions where the relative humidity is no more than 70 %. The product data sheet at the end of this manual Contains details of the ambient temperature range suitable for this appliance. Ensure that the plug is accessible and can be removed from the wall socket at any time. Do not expose the appliance to direct sunlight, and do not position it next to any heat sources (radiators, cookers etc). If this cannot be avoided, however, a suitable insulation must be in installed between the heat source and the unit. The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or similar object . Do not place any objects on top of the unit, and do not otherwise cover it. If the floor is uneven, the height-adjustable feet at the front of the unit can be used to compensate and ensure optimum stability. Ventilation Ensure that there is enough space around the unit so that the air circulation round and behind it is not obstructed. Reversible door If required, the door may be reversed, i. Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Use a suitable socket spanner to remove the three Screws holding the upper hinge to the housing, and then lift off the hinge. Carefully lift up the door and place it on a soft surface to protect it from scratches. Remove the three blind covers for the hinge mounting holes on the opposite side and fit them in the corresponding place on the other side. Ensure that the cover are firmly pushed down into the holes. Remove the two screws on the lower hinge plate and take the plate off. Remove the hinge-pin from the hinge plate, turn the plate through 180° and put back the hinge-pin. Install the hinge plate with the hinge pin facing up on the other side. [. . . ] After cleaning, thoroughly clean all surfaces with fresh water before wiping them completely dry. When reinserting the plug into the wall socket ensure that you have dry hands. Take care not to remove or damage the rating plate inside the cabinet during cleaning. To save energy, the compressor (at the rear) should be cleaned carefully at least twice a year with a brush or a vacuum cleaner. [. . . ]