User manual SEVERIN KS 9789

[. . . ] Dear Customer, Before using the appliance, please read the following instructions carefully and keep this manual for future reference. The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. [. . . ] Do not expose the appliance to direct sunlight, and do not position it next to any heat sources (radiators, cookers etc. If this cannot be avoided, however, suitable insulation must be in installed between the heat source and the unit. The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or similar object. In the case of uneven floors, the adjustable feet on the unit can be used to compensate and ensure optimum stability. set-up dimensions If the refrigerator is installed with its side against a wall, ensure a minimum clearance of 60 mm to ensure that the door can open through 90°. To remove the fresh-storage compartment, the bottle rack must be taken out first. Reversible door If required, the door may be reversed, i. To avoid the risk of personal injury or damage to the unit, two people are needed to reverse the door. Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Before you get started, please note the following: Always ensure that the correct number of washers is used on all hinge bolts and screws. So that the doors can close tightly against the frame, take the Utmost care that they are properly aligned during re-assembly. Remove the four covers C from the housing and inside of The door Replace the covers and their extensions, turned through 180° , on the opposite side. Unscrew the hinge bolt on the inside of the door in the area Take off the refrigerator door. Take out the fixing screws and remove the upper bracket 6. Note the small plastic plate underneath the bracket. Turn the bracket 6 including the small plastic plate through 180° and replace it on the other side of the refrigerator, using the two screw holes adjacent to each other. Unscrew the hinge bolt 2, together with the washers, from the bracket 7, and fit it into the corresponding opening on the opposite side of the bracket 7. Place the refrigerator door onto the hinge bolt 2 on holding bracket 7. Re-insert the hinge bolt of the bracket 6 into the refrigerator door. Fit the four covers C over the bracket and the openings. Take out the cover 10 from the lower panel 1 and replace it on the opposite side. Remove the screw covering caps a and the sealing plugs b. [. . . ] ) Are there any objects on top of the unit which might be vibrating? Water is collecting on the bottom of the unit. Remove the blockage and clean the system. Transporting the appliance To prevent damage to the unit during transport, ensure that all accessories and components inside and around the appliance are securely fastened. [. . . ]