User manual SEVERIN KS 9792

[. . . ] Dear Customer, Before using the appliance, please read the following instructions carefully and keep this manual for future reference. The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. [. . . ] Fit the pin of the centre hinge bracket (10), together with the washers, to the refrigerator door (13). Fit the centre hinge bracket (10) together with the plastic plate (9). Remove both screws from the upper left and replace them on the right. Place the freezer door (18) onto the pin of the centre hinge bracket (10). Fit the pin of the upper hinge bracket (5) to the freezer door (18), and then fit and secure the upper hinge bracket (5). Note: If necessary, the alignment of the doors can be adjusted by slightly loosening the hinge bracket screws, but remember to tighten them afterwards. Replace the top cover (4) and use the screws (1 and 3) to secure it (two screws at the front and two at the rear). Fit the two enclosed spacer elements (2) into the corresponding guide slots on the rear). If the unit has been tilted to more than 30°, wait for about 4 hours before re-connecting it to the mains. Temperature control The unit is re-activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control. Turning the control clockwise will decrease the temperature, while turning it anti-clockwise will increase it. The medium settings are usually most suitable for home use. We recommend using a thermometer to check the actual temperature inside the cabinet and make adjustments as necessary. Following a power interruption, or if the unit has been switched off on purpose, it may take 3 to 5 minutes before it switches on again. In position `0', the cooling function is switched off, though the appliance is still connected to the mains. Interior lighting Changing the light bulb: Remove the plug from the wall socket. Use a suitable tool to release the locking tab (5) and remove The lamp cover (4). Take out the defective bulb and fit a new one (max. Freezer compartment door To ensure that frozen food will not de-frost prematurely, the door to the freezer compartment should be kept closed at all times. This will also prevent an undue build-up of ice and frost. [. . . ] ) Are there any objects on top of the unit which might be vibrating? Water is collecting on the bottom of the unit. Remove the blockage and clean the system. Transporting the appliance To prevent damage to the unit during transport, ensure that all accessories and components inside and around the appliance are securely fastened. [. . . ]