User manual SEVERIN KS 9795

[. . . ] Dear Customer, Before using the appliance, read the following instructions carefully and keep this manual for future reference. The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. [. . . ] Fit the lower hinge bracket (14) on the left of the underside. Remove the cap (19) from the freezer door and the cap (16) from the refrigerator door and replace them on the opposite side of the doors. Take off the caps (17) from the partition between the refrigerator and freezer compartments and remove the screws. Replace both screws on the opposite side and then the caps. Fit the refrigerator door (13) onto the pin (15) of the lower hinge bracket. Fit the pin of the centre hinge bracket (10), together with the washers, to the refrigerator door (13). Fit the centre hinge bracket (10) together with the plastic plate (9). Remove both screws from the upper left and replace them on the right. Place the freezer door (18) onto the pin of the centre hinge bracket (10). Fit the pin of the upper hinge bracket (5) to the freezer door (18), and then fit and secure the upper hinge bracket (5). Note: If necessary, the alignment of the doors can be adjusted by slightly loosening the hinge bracket screws, but remember to tighten them afterwards. Replace the top cover (4) and use the screws (1 and 3) to secure it (two screws at the front and two at the rear). Fit the two enclosed spacer elements (2) into the corresponding guide slots on the rear). If the unit has been tilted to more than 30°, wait for about 4 hours before re-connecting it to the mains. Temperature control The unit is re-activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control. Turning the control clockwise will decrease the temperature, while turning it anti-clockwise will increase it. The medium settings are usually most suitable for home use. We recommend using a thermometer to check the actual temperature inside the cabinet and make adjustments as necessary. Following a power interruption, or if the unit has been switched off on purpose, it may take 3 to 5 minutes before it switches on again. In position `0', the cooling function is switched off, though the appliance is still connected to the mains. [. . . ] There is too much dust on the condenser. Insufficient ventilation: the unit is too close to a wall or other structure or object. Are any adjacent objects affected by the running of the cooling unit (i. ) Are there any objects on top of the unit which might be vibrating? [. . . ]