User manual SEVERIN KS 9804

[. . . ] Freezer Dear Customer, Before using the appliance, the user should read the following instructions carefully. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding CE labelling directives. [. . . ] In the case of uneven floors, the adjustable feet on the unit can be used to compensate and ensure optimum stability. The freezer should be installed at a slight angle in such a way that it leans to the rear: this will ensure that the door will close automatically and cannot be left open by mistake. Ensure, however, that both front feet are set to the same height. Ventilation The heated air around the rear of the freezer must be able to circulate freely. Therefore, ensure that the air circulation behind the unit is not obstructed. Reversible door The design provides for the door to be reversed, i. e. for right-hinged (default installation) to become left-hinged. Use a suitable pointed tool to remove the cover (5). Use a suitable screw-driver to remove the two 3 screws (2) holding the hinge to the freezer housing. Carefully lift up the door and place it on a soft surface to protect it from scratches. Remove the blind cover for the hinge mounting holes (9) and fit it in the 9 4 corresponding place on the right. Ensure that the cover is firmly pushed down into the hole. Pull off the two bolts (7) which keep the lower 8 hinge in position on the right. Unscrew the adjustable (8) foot and re-fit it on the right-hand side. Ensure that the hinge pin is inserted into the guide bushing (hole) on the lower part. Install the upper hinge (3) on the left-hand side. Ensure that the hinge pin is inserted into the guide bushing (hole) on the upper part. The screws should be tightened only after the door is closed and in its proper position. Replace the cover (5) in the corresponding holes on the right. Replace the hinge cover (1) on the upper hinge. 11 Temperature control The temperature control automatically regulates the temperature of the freezer's interior. After switching on, the temperature control should be set to position 5. 20 minutes, the setting should be changed to position 3, which is usually sufficient for home or office use. [. . . ] After a certain period of operation and depending on several factors (e. g. how often the door has been opened), a layer of ice will form inside the freezer compartment. Once the build-up of ice has reached a thickness of 3 to 5 mm, the unit must be de-frosted. The build-up of ice increases the power consumption of the appliance. [. . . ]