User manual SEVERIN KS 9807

[. . . ] The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding CE labelling directives. [. . . ] Use a suitable screw-driver to remove the two screws (2) holding the upper hinge (3) to the housing. Carefully lift up the door and place it on a soft surface to protect it from scratches. Ensure that the cover is firmly pushed down into the hole. Pull out the two bolts (7) which hold the lower right hinge plate (4) and the adjustable foot (6) in position. Remove the adjustable foot (8) on the left and insert it into the corresponding thread on the right. Install the lower hinge plate (4) with the two bolts (7) on the left. Ensure that the hinge pin is inserted into the guide bushing (hole) on the lower part. Install the upper hinge (3) on the left-hand side. Ensure that the hinge pin is inserted into the guide bushing (hole) on the upper part. Replace the cover (5) in the corresponding holes on the right. Replace the hinge cover (1) on the upper hinge. Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The unit is activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control. Temperature settings from 1 – 5 are available. 1 3 5 The cooling function is switched off; however, the appliance is still connected to the mains. To switch off the unit completely, the plug must be removed from the wall socket. This position is used for freezing fresh food. Once the food to be frozen has reached the required deep-freeze temperature, the temperature control can be re-set to an intermediate position. we recommend setting the control initially to position 3. After a certain time, the actual temperature should then be checked with a thermometer, and adjustments made if necessary. [. . . ] € To accelerate defrosting, place one or several containers with hot (but not boiling) water inside the freezer compartment and close the door. € Do not pour water over or inside the unit. € Warning: Do not use any external device or other means (e. € For frequent cleaning we recommend the use of warm water with some mild detergent. [. . . ]