User manual SEVERIN KS 9809

[. . . ] The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding CE labelling directives. [. . . ] Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Before reversing the door, place the unit on its side, ensuring that it rests on a soft, smooth, nondamaging surface. Take out the screws and lift off the top cover. Remove the small panel from the front of the top cover. Reposition the small panel on the other side of the cover. Take off the upper hinge by removing the 3 screws. Take off the door and place it also on a soft, non-damaging surface to protect it against scratching. Remove the hinge cover B from the inside of the door and install the hinge cover A provided into the hinge opening on the other side of the door. Remove both adjustable feet and the screws holding the lower hinge and the foot mounting. Unscrew the hinge pin and reposition it in the other opening in the hinge. Now fit the lower hinge and the foot mounting on the respective opposite sides. Place the door onto the lower-hinge pin. Take out the screws on the top left-hand side of the unit and replace them on the top right. Turn the upper hinge round through 180°. Unscrew the hinge pin and reposition it in the other opening in the hinge. Unscrew the hinge pin and reposition it in the other opening in the hinge. Fit the hinge pin into the corresponding opening in the door and tighten the screws to the secure the upper hinge to the housing. Replace the top cover and secure it by tightening the holding screws. Now change the position of the door handle: Take off the screw covers, remove the screws and then take off the handle. Replace the blind covers on the other side. Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The unit is activated by connecting it to the mains. [. . . ] € To accelerate defrosting, place one or several containers with hot (but not boiling) water inside the freezer compartment and close the door. € Do not pour water over or inside the unit. € Warning: Do not use any external device or other means (e. € For frequent cleaning we recommend the use of warm water with some mild detergent. [. . . ]