User manual SEVERIN KS 9822 HOCHKUHLSCHRANK

[. . . ] Dear Customer, Before using the appliance, please read the following instructions carefully and keep this manual for future reference. The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. [. . . ] Warning: Always disconnect the unit from the mains before Take out the screws and lift off the top cover. Remove the small panel from the front of the top cover. Reposition the small panel on the other side of the cover. Take off the upper hinge by removing the 3 screws. Take off the door and place it also on a soft, non-damaging surface to protect it against scratching. Remove the hinge cover B from the inside of the door and install the hinge cover A provided into the hinge opening on the other side of the door. Take out the screws on the top left-hand side of the unit and replace them on the top right. Turn the upper hinge round through 180°. Unscrew the hinge pin and reposition it in the other opening in the hinge. Unscrew the hinge pin and reposition it in the other opening in the hinge. Fit the hinge pin into the corresponding opening in the door and tighten the screws to the secure the upper hinge to the housing. Replace the top cover and secure it by tightening the holding screws. Remove both adjustable feet and the screws holding the lower hinge and the foot mounting. Now change the position of the door handle: Take off the screw covers, remove the screws and then take off the handle. Remove the blind covers on the other side of the door and reposition the handle in the new location. Replace the blind covers on the other side. Unscrew the hinge pin and reposition it in the other opening in the hinge. Now fit the lower hinge and the foot mounting on the respective opposite sides. Place the door onto the lower-hinge pin. Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The unit is activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. [. . . ] Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. This guarantee is only valid if the appliance has been used in accordance with the instructions, and provided that it has not been modified, repaired or interfered with by any unauthorised person, or damaged through misuse. This guarantee naturally does not cover wear and tear, nor breakables such as glass and ceramic items, bulbs etc. This guarantee does not affect your statutory rights, nor any legal rights you may have as a consumer under applicable national legislation governing the purchase of goods. [. . . ]