User manual SEVERIN KS 9827

[. . . ] The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding CE labelling directives. [. . . ] ρ¬ Do not place any objects on top of the unit, and do not otherwise cover it. ρ¬ If the floor is uneven, the adjustable foot can be used to compensate and ensure optimum stability. Ventilation Ensure that there is enough space around the unit so that the air circulation round and behind it is not obstructed. ) Reversible door If required, the door may be reversed, i. Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Use a suitable pointed tool to remove the cover (5). Use a suitable screw-driver to remove the two screws (2) holding the upper hinge (3) to the housing. Carefully lift up the door and place it on a soft surface to protect it from scratches. Ensure that the cover is firmly pushed down into the hole. Pull out the two bolts (7) which hold the lower right hinge plate (4) and the adjustable foot (6) in position. Remove the adjustable foot (8) on the left and insert it into the corresponding thread on the right. Install the lower hinge plate (4) with the two bolts (7) on the left. Ensure that the hinge pin is inserted into the guide bushing (hole) on the lower part. Install the upper hinge (3) on the left-hand side. Ensure that the hinge pin is inserted into the guide bushing (hole) on the upper part. Replace the cover (5) in the corresponding holes on the right. Replace the hinge cover (1) on the upper hinge. Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The unit is activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control. Temperature settings from 1 – 5 are available. [. . . ] €“ Take care not to remove or damage the rating plate inside the cabinet during cleaning. €“ To save energy, the compressor (at the rear) should be cleaned carefully at least twice a year with a brush or a vacuum cleaner. Trouble-shooting Certain typical sounds can be heard when the appliance is switched on. These sounds are: – caused by the electrical motor within the compressor assembly; during compressor start-up the sound level will be slightly higher for a limited period of time. [. . . ]