User manual SEVERIN KS 9878

[. . . ] Translation from original operating manual Refrigerator for bottles Dear Customer, Before using the appliance, please read the following instructions carefully and keep this manual for future reference. The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. [. . . ] The product data sheet contains details of the ambient temperature range suitable for this appliance. Ensure that the plug is accessible and can be removed from the Wall socket at any time. Do not expose the appliance to direct sunlight, and do not Position it next to any heat sources (radiators, cookers etc). If this cannot be avoided, however, suitable insulation must be in installed between the heat source and the unit. The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or similar object. If the unit is installed next to a wall, a minimum lateral distance of 10 mm is necessary for the door to fully open. If the floor is uneven, the adjustable feet on the unit can be used to compensate and ensure optimum stability. The heated air around the rear of the unit must be able to circulate freely. Therefore, ensure that the air circulation is not obstructed. Warning: Take special care that the ventilation openings in the upper part of the rear panel are not blocked or obstructed. Temperature control The unit is activated by connecting it to the mains. it is only Switched off completely when the plug is removed from the wall socket. The green mains indicator light shows that the unit is connected to the mains. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control (0-5). Turning the control clockwise will decrease the temperature, while turning it anticlockwise will increase it. The temperature can be set within a 0 to 10°C range. The temperature in the cabinet largely depends on factors such as the ambient temperature, the setting and the number of bottles stored. We recommend using a thermometer to check the actual temperature inside the cabinet and make adjustments as necessary. Always ensure that the door is properly closed and that the seal is not obstructed by bottles stored inside the cabinet. Following a power interruption, or if the unit has been switched off on purpose, it may take 3 to 5 minutes before it switches on again. Note: With the temperature control in position `0', only the compressor is switched off, while the fan is still running. Interior lighting The interior light can be switched on by means of the separate On/Off switch. [. . . ] The cooling agent flowing through the circuit. The following table lists possible malfunctions, their probable causes and solutions. In the event of operational problems, check first whether a solution can be found using this table. The problem persists, disconnect the appliance from the mains power and contact our Customer Service Department. [. . . ]