User manual SEVERIN KS 9883

[. . . ] KS 9883 Geräteart Kühlgerät Energieverbrauch : kWh/24 h (Temperatureinstellung: 13°C; Umgebungstemperatur: 25°C) 0, 70 kWh/Jahr (Temperatureinstellung: 13°C; Umgebungstemperatur: 25°C) 256 Der tatsächliche Verbrauch hängt von der Nutzung und vom Standort des Gerätes ab Nutzinhalt Kühlteil, l 110 Klimaklasse N Umgebungstemperatur, °C 16 - 32 Abmessungen, mm 865 x 505 x 495 Masse, kg 34 Elektrische Daten siehe Typenschild Isolationsschaum C5H10 10 ╞ Temperature-controlled wine cabinet Dear Customer, Before using the appliance, the user should read the following instructions carefully. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding CE labelling directives. [. . . ] Hold the door in position and insert the lower hinge (2) in the left-hand side. Secure the hinge with the two screws (1). Controls and interior light ● Before the unit is connected to the mains power after installation, it should be left standing in position for about 24 hours. 13 The unit is activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. Note: with the temperature control in its OFF-position, only the compressor is switched off. The temperature in the cabinet can be adjusted by using the temperature control. we recommend setting the temperature control initially to Normal. After a certain time, the actual temperature should then be checked with a thermometer, and adjustments made if necessary. Turning the temperature control clockwise will decrease the temperature, while turning anti-clockwise will increase it. The interior light can be switched on by means of the separate On/Off switch. Changing the interior light bulb - Remove the plug from the wall socket. - Use a suitable screw-driver to remove the screw (5) behind the light cover (4). - Slide the cover (4) slightly to the rear and take it off. - Take out the defective bulb (1) and fit a new 10W-bulb (max. - Slide the cover (4) back into position, replace the screw (5) and tighten it. Storing wine - The temperature in the cabinet largely depends on factors such as the ambient temperature, the setting and the number of wine bottles stored. - Initially, the temperature control should be set to position Normal. If the cooling effect is too strong, turn the temperature control anti-clockwise (towards Min); if it is insufficient, turn it clockwise (towards Max). - Because of the way the air circulates, different areas of the refrigerator cabinet are affected differently. The coldest area is in the lower part of the cabinet, and is most suitable for storing wines that require more cooling, such as white wines. - Always ensure that the door is properly closed and that the seal is not obstructed by bottles stored inside the cabinet. [. . . ] Possible cause and solution - Unit is not connected to the mains power. On an uneven floor) or there is contact between the rear-mounted cooling circuit and the power cord, the wall or other object or surface. Verify that all installation instructions in this manual have been correctly complied with. The seal must be re-fitted properly, by pressing in the inner part of the seal. [. . . ]