User manual SEVERIN KS 9888

[. . . ] Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding CE labelling directives. — Do not operate this unit by means of a transformer or, together with other electrical appliances, by means of an extension cable. [. . . ] Caution: Reversing the door requires changes to the electrical system. Do not attempt to reverse the door without contacting the customer service. Control panel and interior light ● Before the unit is connected to the mains power after installation, it should be left standing in position for about 2 hours. — The unit has two temperature zones. 12 ● For each zone, the temperature range can be set between 4 °C and 18°C (40 °F and 65 °F). The unit is activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The actual temperature inside the cabinet is shown in the temperature display. The temperature settings for both zones can be adjusted using the -button (upper zone) and the -button (lower zone). The temperature can be changed in 1-degree steps (°C or °F). During the adjustment phase, the display blinks. The temperature display format can be changed by pressing °F/°C. The selected format is indicated by the active light next to the appropriate temperature symbol. The interior light is switched on and off by pressing the button. Changing the interior light bulb – Switch off the interior light. €“ Remove the plug from the wall socket. €“ Use a suitable screwdriver to remove the screw from the lamp cover (1). €“ Take off the lamp cover (1) by slightly pulling down its lower end. €“ Remove the defective bulb (2) from its housing (3) and fit a new 10W-bulb (max. €“ Slide the cover (1) back into position, replace the screw and tighten it. Storing wine – The temperature in the cabinet largely depends on factors such as the ambient temperature, the setting and the number of wine bottles stored. If the ambient temperature falls below 20 or exceeds 25°C, the maximum achievable storage temperature inside the unit can vary accordingly. [. . . ] This heat is caused by dissipation of the heat generated inside the cabinet. The following table lists the possible malfunctions, their probable causes and solutions. In the event of operational problems, check first whether a solution can be found using this table. If the problem persists, disconnect the appliance from the mains power and contact our Customer Service Department. [. . . ]