User manual SEVERIN KS 9890

[. . . ] The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding CE labelling directives. [. . . ] In the case of uneven floors, the height-adjustable feet on the unit can be used to compensate and ensure optimum stability. Ventilation Ensure that there is enough space around the unit so that the air circulation round and behind it is not obstructed. For right-hinged (default installation) to become left-hinged. 14 Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Remove the four screw covers (11) and the screws (10). Remove the top panel (9), and the cover plate (8) from the front. Remove the two screws (6) securing the upper hinge plate (5) on the right-hand side. Carefully lift up the door and place it on a suitable surface to protect it from scratches. Take off the white plug (7) and re-position it in the corresponding hole on the right-hand side, pushing it firmly down. Remove the two screws (1) securing the lower hinge plate (2) on the right-hand side. Take out the adjustable foot (4) and re-position it on the right-hand side. Mount the lower hinge plate (2) using both screws (1) in its new position on the left. Ensure that the plate is aligned parallel to the side edge of the unit. Ensure that the hinge pin of the lower hinge plate is inserted into the guide bushing (hole) in the door. Mount the upper hinge plate (5) using both screws (6) in its new position on the left. Ensure that the hinge pin is inserted into the guide bushing (hole) in the door. Close the door and ensure that it is properly aligned before fully tightening the screws of the upper and lower hinge plates. Fit the top panel (9) on the unit and – with the door open – replace the cover plate (8) into the opening on the right-hand side of the front. Replace the screws (10) and screw covers (11) on the top panel (9). Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The temperature control automatically regulates the temperature inside the different compartments. Min cold setting Normal colder (normal) setting Max coldest setting Note: The operating temperature in the freezer largely depends on factors such as the ambient temperature and that of the food to be newly frozen. [. . . ] € For frequent cleaning we recommend the use of warm water with some mild detergent. Any accessories should be cleaned separately with soapy water. € Do not use abrasives or harsh cleaning solutions or any cleaning agents that contain alcohol. € After cleaning, thoroughly clean all surfaces again with fresh water before wiping them completely dry. [. . . ]