User manual SEVERIN KS 9892

[. . . ] The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding CE labelling directives. [. . . ] ) Reversible door If necessary, the door may be reversed, i. Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Remove the four screw covers (11) and the screws (10). Remove the entire top panel (9), and the cover plate (8). Remove the two threaded bolts (6) securing the upper hinge plate (5) on the right-hand side. Carefully lift up the door and place it on a suitable surface to protect it from scratches. Take off the white plug (7) and re-position it in the corresponding hole on the right-hand side, pushing it firmly down. Remove the two threaded bolts (1) securing the lower hinge plate (2) on the right-hand side. Take out the left-hand adjustable foot (4) and fit it on the opposite side. Mount the lower hinge plate (2) in its new position on the left-hand side, using the threaded bolts (1). Ensure that the hinge plate is aligned parallel to the side edge of the fridge. Ensure that the lower hinge pin is inserted into the corresponding guide bush on the door. Mount the upper hinge plate (5) in its new position on the left-hand side, using the two threaded bolts (6). Ensure that the hinge pin is inserted into the corresponding guide bush in the door. Ensure that the door is in its properly closed position before tightening the bolts holding the lower and upper hinge plates. Open the fridge door, place the top panel (9) on top of the unit and fit the cover plate (8) into the opening on the right-hand side of the top panel. Replace the screws (10) and screw covers (11) on the top panel (9). Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The unit is re-activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control. Turning the control clockwise will decrease the temperature, while turning it anti-clockwise will increase it. [. . . ] When re-inserting the plug into the wall socket ensure that you have dry hands. € To save energy and to ensure optimum performance, the compressor (at the rear) should be carefully cleaned at least twice a year, with a brush or a vacuum cleaner. € Take care not to remove or damage the rating plate inside the cabinet during cleaning. Defrosting the refrigerator cabinet : The integral vapouriser is sealed in foam in the rear wall; you may therefore notice a build-up of frost around the rear area. [. . . ]