User manual SEVERIN KS 9893

[. . . ] The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. This product complies with all binding CE labelling directives. [. . . ] Ensure that the plate is aligned parallel to the side edge of the unit. Ensure that the hinge pin of the lower hinge plate is inserted into the guide bushing (hole) in the door. Mount the upper hinge plate (5) using both screws (6) in its new position on the left. Ensure that the hinge pin is inserted into the guide bushing (hole) in the door. Close the door and ensure that it is properly aligned before fully tightening the screws of the upper and lower hinge plates. Fit the top panel (9) on the unit and – with the door open – replace the cover plate (8) into the opening on the right-hand side of the front. Replace the screws (10) and screw covers (11) on the top panel (9). Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The unit is activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control. Turning the control clockwise will decrease the temperature, while turning it anti-clockwise will increase it. € After switching on, the temperature control should be set to its highest setting. 30 minutes, the temperature should be changed to a medium setting, which is usually sufficient for home or office use. Following a power interruption, or if the unit has been switched off on purpose, it may take 3 to 5 minutes before it switches on again. Note: In position ‘0’, the cooling function is switched off, though the appliance is still connected to the mains. 16 Interior lighting Changing the light bulb: – Remove the plug from the wall socket. € Use a suitable screw-driver to remove the screw holding the light cover and take the cover off. € Take out the defective bulb and fit a new one (max. € Put the cover back into position, replace the screw and tighten it. It may take 3 to 5 minutes before it switches on again. Freezer compartment door To ensure that frozen food will not de-frost prematurely, the door to the freezer compartment should be kept closed at all times. [. . . ] Too much food has been stored in the appliance. Insufficient ventilation: the unit is too close to a wall or other structure or object. Are any adjacent objects affected by the running of the cooling unit (i. ) Are there any objects on top of the unit which might be vibrating? [. . . ]