User manual SEVERIN LS 0680

[. . . ] Otherwise there is a real risk of burns. To prevent burns, ensure that the curler is kept well away from the scalp. Do not use the appliance on synthetic hairpieces or wigs, as the heat emitted might cause damage to the synthetic fibres. Before the appliance is used, the main body as well as any attachments fitted should be checked thoroughly for any defects. [. . . ] No responsibility will be accepted if damage results from improper use, or if these instructions are not complied with. In order to comply with safety regulations and to avoid hazards, repairs of electrical appliances must be carried out by qualified personnel, including the replacement of the power cord. If repairs are needed, please send the appliance to one of our customer service departments. The address can be found in the appendix to this manual. Sufficiently cool, turn the locking-ring clockwise and pull the attachment off. Operation Make sure the appliance is used on dry hair only. - Fit the desired attachment to the appliance. - Let the curler heat up for approximately 5 minutes. - The individual attachments are used as described below. - Curling tongs - Divide the hair into separate strands, grip the end of a strand with the clamp and curl it up to the hairline. The integrated swivel makes it easy to use the curler in this way. - The individual attachments are used as described below. – Make sure the hot parts of the curler are kept away from the scalp. - Let the hair cool down sufficiently before brushing it out. - The individual attachments are used as described below. - The round brush is designed for shaping the hair. To achieve this, the hair should be divided into single strands (not too thick) and then spread evenly over the brush, turning them inwards or outwards as desired. - Let the hair cool down sufficiently before brushing it out. 10 Switch positions The appliance is equipped with a 3-position switch allowing for the following settings: Functions: 0 = Off 1 = Half power 2 = Full power Fitting / removing attachments Fitting: Hold the appliance with the switch facing up. Push the metal studs on the attachment into the grip body so that they are properly aligned with the corresponding openings in the connecting piece. [. . . ] – ■ - disconnected from the power supply and has cooled down completely. To avoid the risk of electric shock, do not clean the appliance with water and do not immerse it in water. do not use abrasives or harsh cleaning solutions. If necessary, the housing may be wiped with a dry lint-free cloth. [. . . ]