User manual SEVERIN MD 7720

[. . . ] Rating label Important safety instructions Before the appliance is used, the main body as well as any attachment fitted should be checked thoroughly for any defects. Should the appliance, for instance, have been dropped onto a hard surface, it must not be used any longer: even invisible damage may have adverse effects on the operational safety of the appliance. Do not let children operate the water jet without supervision. Always ensure that the selected jet attachment is correctly and safely fitted. [. . . ] - Fit the selected jet attachment to the power unit in such a way that the nozzle opening faces in the same direction as the water control slide switch. Make sure that the attachment is properly and securely connected. To ensure that the jet nozzles are clean and without blockage, a short water burst at the highest pressure setting (7) should be directed into the sink before and after use. base and its power cord must be thoroughly checked for any signs of damage. In the event of such damage being found, the water jet must not be used. In case of any malfunction during use, remove the plug from the wall socket first. When removing the plug from the wall socket, ensure that your hands are dry. No responsibility is accepted if damage results from improper use, or if these instructions are not complied with. This appliance is intended for domestic use only and not for commercial applications. In order to comply with safety regulations and to avoid hazards, repairs of electrical appliances must be carried out by qualified personnel, including the replacement of the power cord. If repairs are needed, please send the appliance to one of our customer service departments. The address can be found in the appendix to this manual. Positioning/Mounting Before operation, the unit must be placed on a safe non-slip surface, or fitted horizontally on the wall. Mounting the wall bracket - Drill two 6 mm holes aligned horizontally with the mounting holes in the wall bracket. - The bracket can now be mounted on the wall, ensuring that it is securely held in place. - Fit the housing by sliding it down over the bracket until it is heard locking into place. - Replace the insert in the storage unit. When positioning the insert, make sure that the lower part of the insert rim is placed on the side studs of the lid. This will ensure that the insert is lifted up - Afterwards, use the pressure regulator to select the desired pressure setting (1 = low, 7 = high). We recommend starting with the lowest setting 1, especially if the user is susceptible to bleeding gums, or if the water jet is being used by children. - With your head held over the sink, guide the jet attachment to your teeth and gums. When the water control slide switch is pushed up, the water is forced through the jet nozzles and will run from the slightly opened mouth into the sink. [. . . ] Pour out any remaining water from the water tank after use. Always remove the jet attachments after use and clean them thoroughly under running warm water. Carefully wipe them dry afterwards and replace them in the storage unit. Make sure that the power unit is completely dry before is replaced to the charging base. [. . . ]