User manual SEVERIN PG 2786

[. . . ] die Garantie erlischt bei Eingriff nicht von uns autorisierter Stellen. — During operation, the barbecue grill must be placed on a level, heat-resistant surface, impervious to splashes and stains. When grilling food with a high fat 10 ● ● ● ● ● ● ● ● ● ● or moisture content, splashes are not always avoidable. Do not fit the wind screen if the appliance is used indoors. [. . . ] Ensure that the grill is not stored outdoors, or in any other location where it might be subjected to extremes of temperature or high humidity. No responsibility can be/will be accepted if damage results from improper use, or if these instructions are not complied with. In order to comply with safety regulations and to avoid hazards, repairs of electrical appliances must be carried out by qualified personnel. If repairs are needed, please send the appliance to one of our customer service departments. 11 The address can be found in the appendix to this manual. Grill with additional base stand: Assemble the base stand according to the schematic diagram supplied, and then place the grill onto the stand. The small feet under the grill connect with the tops of the vertical legs of the base stand. Ensure that the grill and base stand are placed in a safe and stable position. The power cord should be routed in such a way that no one is likely to trip over it. Heating element The junction box contains a safety switch. Place the grill pan into the plastic housing first, and then fit the heating element inside the grill pan and housing. The safety switch is activated automatically when the heating element has been properly fitted. If not fitted correctly, the appliance can not be switched on. - Clean the grill rack and grill pan with warm soapy water. Place the grill pan inside the plastic housing. Place the heating element into the grill pan. If required, additional accessories may be fitted according to the diagram shown in the instructions. - Fill the grill pan with water up to the ‘Max’ marking. - Let the grill heat up for approximately 5 minutes without any food on the rack. This will lessen the smell typically encountered when first switching on a new grill (a slight smell and a little smoke may be emitted - ensure sufficient ventilation). Grilling - The grill pan must be filled with water up to the ‘Max’ marking. - Fit the heating element; then ensure that the grill rack is placed correctly on to the element. [. . . ] Disposal Do not dispose of old or defective appliances in domestic garbage, but only through public collection points. ● Do not use metallic pads or abrasive 12 cleaning agents. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. This guarantee is only valid if the appliance has been used in accordance with the instructions, and provided that it has not been modified, repaired or interfered with by any unauthorised person, or damaged through misuse. [. . . ]