User manual SEVERIN PG 8520

[. . . ] Should the appliance, for instance, have been dropped onto a hard surface, it must no longer be used: even invisible damage may have adverse effects on the operational safety of the appliance. During operation, the barbecue grill must be placed on a level, heat-resistant surface, impervious to splashes and stains. When grilling food with a high fat 4 or moisture content, splashes are not always avoidable. Do not fit the wind screen if the appliance is used indoors. [. . . ] No responsibility can be/will be accepted if damage results from improper use, or if these instructions are not complied with. This barbecue grill is intended for domestic use only and not for commercial applications. In order to comply with safety regulations and to avoid hazards, repairs of electrical appliances must be carried out by qualified personnel. If repairs are needed, please send the appliance to one of our customer service departments. The address can be found in the appendix to this manual. the grill onto the stand. The small feet under the grill connect with the tops of the vertical legs of the base stand. Ensure that the grill and base stand are placed in a safe and stable position. The power cord should be routed in such a way that no one is likely to trip over it. Reflector tray If your grill model comes with a reflector tray, the tray can be placed right onto the water surface underneath the heating element when using the grill outdoors. Before using for the first time - Remove any packaging materials from the appliance. - Clean the grill rack and grill pan with warm soapy water. Place the heating element into the grill pan. Slide the safety locking device for the heating element ­ located on the housing to the left of the electric junction box ­ to the right. Use a suitable screwdriver to tighten the fixing screws. If required, additional accessories may be fitted according to the diagram shown in the instructions. - Fill the grill pan with water up to the `Max' marking. - Let the grill heat up for approximately 5 minutes without any food on the rack. This will lessen the smell typically encountered when first switching on a new grill (a slight smell and a little smoke may be emitted - ensure sufficient ventilation). Grilling - The grill pan must be filled with water up to the `Max' marking. - Insert the plug into a suitable earthed power-outlet. - Switch-type grill models: 5 Grill with additional base stand: Assemble the base stand according to the schematic diagram supplied, and then place - Set the switch to its on position. - Thermostat-controlled models: - Set the thermostat control knob to its `Max' position. [. . . ] If within the guarantee period, please also provide the guarantee card and proof of purchase. Nicht mit Alufolie, Grillschale o. ä. Do not cover with aluminum foil, grill tray etc. Ne couvrez ni avec un papier aluminium ni avec la plaque etc. Niet bedekken met aluminiumfolie, grillplaat enz. [. . . ]