User manual SEVERIN TO 2034

[. . . ] Warning: the door as well as the accessible surfaces of the appliance become hot during operation - burns can result from touching these hot parts. Always ensure that the crumb tray is properly fitted under the heating elements while the appliance is in use. Overheated oil or fat may tend to ignite. Therefore do not overfill the baking tray. [. . . ] The address can be found in the appendix to this manual. Turn the unit off, turn the switch to position 0. To pre-programme the cooking time, turn the switch clockwise to the desired time. sufficient ventilation must be ensured at all times. After the pre-programmed time has elapsed, an acoustic signal indicates that the heating elements are switched off. To switch off the entire appliance, the heating elements must be switched off as well. Indicator lamp The indicator lamp lights up when the appliance is switched on. It goes out once the pre-programmed time has elapsed, or if the switch is turned back to position 0. Start up - Clean the appliance (see General care and cleaning) and remove any packing materials completely. sufficient ventilation must be ensured at all times. When the appliance is first switched on, a slight smell may be emitted. This is normal and will only last for a very short time. - Pre-heat the oven compartment for several minutes with the door closed, using both heating elements. Set the temperature control knob to the required level and use the timer control to select the desired pre-heating time. - Place the food to be cooked on the grill rack. When cooking food containing fat or moisture, use the baking tray to stop any drips into the interior of the appliance. For baking or grilling from above, either the upper or the upper and lower elements may be selected. The switch settings may be changed during the cooking process. After the pre-programmed cooking time has elapsed, the timer will automatically switch off the heating elements. To interrupt the cooking process, or to switch off the oven during continuous operation, set the timer switch to 0. [. . . ] Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. This guarantee is only valid if the appliance has been used in accordance with the instructions, and provided that it has not been modified, repaired or interfered with by any unauthorised person, or damaged through misuse. This guarantee naturally does not cover wear and tear, nor breakables such as glass and ceramic items, bulbs etc. This guarantee does not affect your statutory rights, nor any legal rights you may have as a consumer under applicable national legislation governing the purchase of goods. [. . . ]