User manual SEVERIN TO 2035

[. . . ] Warning: the door as well as the accessible surfaces of the appliance become hot during operation. Burns can occur from touching the hot parts!Before the appliance is used, the reflector sheet must be fitted in its proper position underneath the bottom heating elements. Overheated oil or fat may tend to ignite. [. . . ] Use the holding clamps to secure the food in the center of the spit. Wings of a chicken) should be held in with a toothpick, a piece of string or other suitable means. This ensures that no part of the food can protrude or come off during the cooking process. - Inserting and removing the rotating spit: - Once the food has been securely attached, place the spit onto the handle assembly. Ensure that the indentations in the handle assembly fit into the corresponding recesses in the spit. - Slide the spit end-piece with the drive 9 Temperature control With the temperature control knob, the temperature can be set to the desired level. The indicator lamp lights up after the timer is activated. Once the pre-set temperature has been reached, the indicator lamp switches off. 5-position switch settings ● Both heating elements and rotating spit switched off. Upper heat Upper heat with rotating spit Upper heat and lower heat Lower heat The heating elements will only be switched unit connection into the drive unit (see picture II). - Place the idle end of the spit into its holding bracket on the other side (see picture I). - To remove the rotating spit, follow these steps in reverse order. Start up - Clean the appliance (see General care and cleaning) and remove any packing materials completely. This is normal and will only last for a very short time. - Pre-heat the oven compartment for several minutes with the door closed, using both heating elements. Set the temperature control knob to the required level and use the timer control knob to select the desired pre-heating time. The indicator lamp switches off once the preset temperature has been reached. The appliance is now pre-heated and ready for use. - Place the food to be cooked on the baking rack. When cooking food containing fat or moisture, use the baking tray to stop any dripping into the interior of the appliance. When using the rotating spit, always ensure that the baking rack and baking tray are properly inserted into one of the lower guide rails. - The baking tray must always be placed on the baking rack and inserted into one of the guide rails. [. . . ] Make sure that the reflector sheet is fitted in its proper position underneath the heating elements after cleaning. Disposal Do not dispose of old or defective appliances in domestic garbage; this should only be done through public collection points. ● Do not use abrasives , harsh cleaning solutions or spray-type oven cleaners. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. [. . . ]