User manual SEVERIN TO 2058

[. . . ] Every time the appliance is used, the main body including the power cord as well as any attachment fitted should be checked thoroughly for any defects. Should the appliance, for instance, have been dropped onto a hard surface, or if excessive force has been used to pull the power cord, it must no longer be used: even invisible damage may have adverse effects on the operational safety of the appliance. Before the appliance is used, the crumb Tray must be fitted in its proper position under the lower heating elements. Therefore do not overfill the baking tray; this will prevent fat from dripping onto the heating elements below. [. . . ] This ensures that no part of the food can protrude or come off during the cooking process. Inserting and removing the rotating spit: Once the food has been securely Attached, place the spit onto the handle assembly. Ensure that the spit is safely supported in the recesses in the handle. Slide the spit end-piece with the drive Unit connection into the drive unit (see picture II). Place the idle end of the spit into its holding bracket on the opposite side (see picture I). To remove the rotating spit, follow these steps in reverse order. Pizza stone Always place the pizza stone on the Middle of the grill rack before inserting the rack into the appliance. Preheat the appliance to the required temperature as described in the section Operation. With certain pre-baked pizzas made from especially light dough, the pre-heating phase should be shortened; this is to prevent the bottom layer of the pizza dough from browning too fast. After pre-heating, open the door and use a spatula to place the pizza on the centre of the stone. The pizza should be slightly smaller than the stone so that there is a clear space all round it. The pizza is ready once the cheese topping has melted and the bottom of the dough is slightly brown. Use a spatula for removing the pizza and serving it. Before using the appliance for the first time, let it heat up for 10 minutes with both heating elements on. When the appliance is switched on for the first time, a slight smell may be emitted. This is normal and will only last for a very short time. For that reason, adequate ventilation should be ensured by opening windows or balcony doors. Operation Before using the appliance, make sure That the crumb tray is fitted in its proper position underneath the lower heating element. Pre-heat the oven compartment for several minutes with the door closed, using both heating elements. Set the temperature control knob to the required level and use the timer control knob to select the desired pre-heating time. Place the food to be cooked on the baking rack. When cooking food containing fat or moisture, use the baking tray to stop any dripping into the interior of the appliance. [. . . ] Guarantee This product is guaranteed against defects in materials and workmanship for a period of two years from the date of purchase. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. This guarantee is only valid if the appliance has been used in accordance with the instructions, and provided that it has not been modified, repaired or interfered with by any unauthorised person, or damaged through misuse. This guarantee naturally does not cover wear and tear, nor breakables such as glass and ceramic items, bulbs etc. [. . . ]