User manual SEVERIN VKS 8816

[. . . ] Dear Customer, Read the complete instruction manual carefully before you start to use the appliance. The appliance is only to be used by persons who are familiar with the safety instructions. If you pass it on, attach these instructions as well. intended Use · The appliance is designed for We are not liable for possible defects in the case of abnormal handling or disregard of the instructions given by this manual. [. . . ] The appliance can be operated at a humidity of max. The surrounding temperature, at which the appliance can be operated, can be taken from the appliance specification sheet at the end of this manual. Bear in mind that you can pull the power Protect the appliance from direct insolation. It should not be installed near heat sources (stove, heater, etc. If this, however, cannot be avoided, you should put isolation between the heat source and the appliance. You must not imbed the appliance in a cabinet. The installation of the fridge directly under a board or a cabinet is disallowed. The unevenness of the floor can be compensated with the two vertically adjustable screw-in feet in the front, so that safe stability is attained. Installation measures If the appliance is placed sideways on a wall, you will leave a lateral gap of at least 60 mm, so that the doors of the appliance can open in a 90-degree angle. In order to be able to remove the VeggiBox completely from the appliance, detach the bottle compartment if necessary. The air warmed behind the appliance needs to circulate freely. For this reason, the circulation of air cannot be compromised. Do not cover possible existing ventilation openings in the back area of the top cover plate!Before you connect the appliance, you have to make sure that itself and the power plug do not show any transport damages. Connect the appliance only to a shockproof outlet. The mains voltage has to correspond to the one stated on the tool identification plate. The appliance complies with the guidelines that are obligatory for CE marking. Do not connect the appliance to an inverter · The power plug should not touch the back- The appliance can be put into operation by plugging the mains plug into the point. A complete switching-off only occurs by pulling the mains plug. If the appliance has been disconnected from the mains, wait approx. 5 minutes after plugging in the mains plug before setting the temperature controller to the desired position. The temperature adjustment for the refrigerator compartment is set via the controller on the lighting inside the refrigerator. [. . . ] More details on temperature settings can be taken from the chapter `Controls and Display'. operation Noises There might be some typical operation noises when the appliance is turned on. these are: · Noise of the electric motor is arising from the working compressor. When the compressor starts to operate, then the noises get slightly louder for a short time. [. . . ]