User manual SEVERIN WL 6852

[. . . ] Electric heating appliances operate at very high temperatures. Do not touch any part of the appliance except the housing. Burns can occur from touching the hot parts. Do not use the appliance on synthetic hair-pieces or wigs. [. . . ] Children should be supervised to ensure that they do not play with the appliance. No responsibility will be accepted if damage results from improper use, or if these instructions are not complied with. This appliance is intended for domestic use only and not for commercial applications. In order to comply with safety regulations and to avoid hazards, repairs of electrical appliances must be carried out by qualified personnel, including the replacement of the power cord. If repairs are needed, please send the appliance to one of our customer service departments. The address can be found in the appendix to this manual. Functions: 0 = Off 1 = Half power 2 = Full power For a cooler air-flow, press the cool-air button `cool' and slide it forward. Removing and changing the attachments - To remove any attachment, press and hold the lock-/release button on the housing, rotate the attachment anticlockwise until the dot mark is aligned with the arrow symbol on the housing, and pull it off from the front. - To fit any attachment, follow the same steps in reverse order while applying only light pressure, making sure the dot mark is aligned with the arrow symbol. Lock the attachment in place by turning it clockwise until both arrow symbols are aligned. - Without any attachment fitted, the appliance can be used as a hair dryer. Use - The round brush is designed for shaping the hair. To achieve this, the hair should be divided into single strands (not too thick) and then spread evenly over the brush, turning them inwards or outwards as desired. - Apply for a few seconds at a time only, while letting the hot air take effect on the hair. - Let the hair cool down sufficiently before brushing it out. Round-brush with retractable bristles As the hot air heats up the metal cylinder, the heat emitted has a direct effect on the hair. The retractable brush is used in the same way as the round brush. The bristles can be retracted by pressing the lever on the attachment. Models with IONIC function The IONIC function facilitates gentle, easy hair styling by preventing a static charge in the hair. It uses the build-up of a negative 'ion-cloud' to prevent 'flyaway' hair caused by a positive charge. The IONIC function is automatically enabled during use, irrespective of the switch settings. Operation Switch positions The appliance is equipped with a 3-position switch allowing for the following settings: 9 Note: with a dry lint-free cloth. - After use, remove loose hair from the attachment used. - Always check the air intake openings for accumulated lint particles or hair and remove any found. [. . . ] Make sure the curling-attachment is used on dry hair only - it is not intended for styling wet hair. - Divide the hair into separate strands. - Take up a strand with the clamp and curl it up to the hairline. Leave the hair curled up for a few seconds. [. . . ]